To explore the effect of neodymium (Nd) on the deformation mechanisms of Mg–Zn alloys, texture and lattice strain developments of hot-rolled Mg–Zn (Z1) and Mg–Zn–Nd (ZN10) alloys were investigated using in situ synchrotron diffraction and compared with elasto-viscoplastic self-consistent simulation under tensile loading. The Nd-containing ZN10 alloys show much weaker texture after hot rolling than the Nd-free Z1 alloy. To investigate the influence of the initial texture on the texture and lattice strain evolution, the tensile tests were carried out in the rolling and transverse direction. During tension, the {002} texture components develop fast in Z1, which was not seen for ZN10. On the other hand, fiber // loading direction (LD) developed in both alloys, although it was faster in ZN10 than in Z1. Lattice strain investigation showed that // LD-oriented grains experienced plastic deformation first during tension, which can be related to basal slip activity. This was more apparent for ZN10 than for Z1. The simulation results show that the prismatic slip plays a vital role in the plastic deformation of Z1 directly from the beginning. In contrast, ZN10 plastic deformation starts with dominant basal slip but during deformation prismatic slip becomes increasingly important.

The Nb-V-Ti-N-C system microelements coupling precipitation behavior in high strength naval steel was thermodynamically analyzed. The effects of micron/nano particles on the microstructure, mechanical properties, and corrosion resistance were also studied by an in situ scanning electron microscopy (SEM) tensile test, transmission electron microscopy (TEM) analysis, and electrochemical polarization measurements. The results show that the solid solution amount of Nb, V, Ti, N, or C decreases in the steels as the temperature decreases. Carbonitrides begin to precipitate at 1506.39 °C in N1 steel, and the carbonitrides are nano-scale. Meanwhile, carbonitrides begin to precipitate at 1628.74 °C in N2 steel, which is 116.69 °C higher than the corresponding liquidus temperature of 1512.05 °C; carbonitrides with micron scale are formed in the metal melt. The tensile test revealed that with the increase in titanium content from 0.05% to 0.1%, the strength increases while the elongation decreases. The in situ SEM test results indicated that lower plasticity are associated with the carbonitrides of micron-scale, which are the micro crack sources under stress. Polarization test results indicated that pitting corrosion may easily occur at the abnormally large-sized (Nb, V, Ti)(C, N) carbonitrides.