We propose and discuss a complete framework for estimating significant changes in the average time-frequency density of energy of event-related signals. Addressed issues include estimation of time-frequency energy density (matching pursuit and spectrogram), choice of resampling statistics to test the hypothesis of change in one small region (resel), and correction for multiplicity (false discovery rate). We present estimation of the significance of event-related electroencephalograph desynchronization and synchronization (ERD/ERS) in the time-frequency plane. Complete software implementing all the discussed steps is freely available from the Internet at http://brain.fuw.edu.pl//spl ap/durka/tfstat.
This article concerns one of the most important problems of brain-computer interfaces (BCI) based on Steady State Visual Evoked Potentials (SSVEP), that is the selection of the a-priori most suitable frequencies for stimulation. Previous works related to this problem were done either with measuring systems that have little in common with actual BCI systems (e.g., single flashing LED) or were presented on a small number of subjects, or the tested frequency range did not cover a broad spectrum. Their results indicate a strong SSVEP response around 10 Hz, in the range 13–25 Hz, and at high frequencies in the band of 40–60 Hz. In the case of BCI interfaces, stimulation with frequencies from various ranges are used. The frequencies are often adapted for each user separately. The selection of these frequencies, however, was not yet justified in quantitative group-level study with proper statistical account for inter-subject variability. The aim of this study is to determine the SSVEP response curve, that is, the magnitude of the evoked signal as a function of frequency. The SSVEP response was induced in conditions as close as possible to the actual BCI system, using a wide range of frequencies (5–30 Hz, in step of 1 Hz). The data were obtained for 10 subjects. SSVEP curves for individual subjects and the population curve was determined. Statistical analysis were conducted both on the level of individual subjects and for the group. The main result of the study is the identification of the optimal range of frequencies, which is 12–18 Hz, for the registration of SSVEP phenomena. The applied criterion of optimality was: to find the largest contiguous range of frequencies yielding the strong and constant-level SSVEP response.
24 September 2012 in IEEE Transactions on Neural Systems and Rehabilitation Engineering
A new multiclass brain-computer interface (BCI) based on the modulation of sensorimotor oscillations by imagining movements is described. By the application of advanced signal processing tools, statistics and machine learning, this BCI system offers: 1) asynchronous mode of operation, 2) automatic selection of user-dependent parameters based on an initial calibration, 3) incremental update of the classifier parameters from feedback data. The signal classification uses spatially filtered signals and is based on spectral power estimation computed in individualized frequency bands, which are automatically identified by a specially tailored AR-based model. Relevant features are chosen by a criterion based on Mutual Information. Final recognition of motor imagery is effectuated by a multinomial logistic regression classifier. This BCI system was evaluated in two studies. In the first study, five participants trained the ability to imagine of the right hand, left hand and feet in response to visual cues. The accuracy of the classifier was evaluated across four training sessions with feedback. The second study assessed the information transfer rate (ITR) of the BCI in an asynchronous application. The subjects' task was to navigate a cursor along a computer rendered 2-D maze. A peak information transfer rate of 8.0 bit/min was achieved. Five subjects performed with a mean ITR of 4.5 bit/min and an accuracy of 74.84%. These results demonstrate that the use of automated interfaces to reduce complexity for the intended operator (outside the laboratory) is indeed possible. The signal processing and classifier source code embedded in BCI2000 is available from https://www.brain-project.org/downloads.html.
28 September 2017 in IEEE Transactions on Neural Systems and Rehabilitation Engineering
We present an efficient implementation of braincomputer interface (BCI) based on high-frequency steady state visually evoked potentials (SSVEP). Individual shape of the SSVEP response is extracted by means of a feedforward comb filter, which adds delayed versions of the signal to itself. Rendering of the stimuli is controlled by specialized hardware (BCI Appliance). Out of 15 participants of the study, 9 were able to produce stable response in at least 8 out of 10 frequencies from the 30-39 Hz range. They achieved on average 96±4% accuracy and 47±5 bit/min information transfer rate (ITR) for an optimized simple 7-letter speller, while generic full-alphabet speller allowed in this group for 89±9% accuracy and 36±9 bit/min ITR. These values exceed the performances of high-frequency SSVEP-BCI systems reported to date. Classical approach to SSVEP parametrization by relative spectral power in the frequencies of stimulation, implemented on the same data, resulted in significantly lower performance. This suggests that specific shape of the response is an important feature in classification. Finally, we discuss the differences in SSVEP responses of the participants who were able or unable to use the interface, as well as the statistically significant influence of the layout of the speller on the speed of BCI operation.