Charging directly affects the burden distribution of a blast furnace, which determines the gas distribution in the shaft of the furnace. Adjusting the charging can improve the distribution of the gas flow, increase the gas utilization efficiency of the furnace, reduce energy consumption, and prolong the life of the blast furnace. In this paper, a mathematical model of blast furnace charging was developed and applied on a steel plant in China, which includes the display of the burden profile, burden layers, descent speed of the layers, and ore/coke ratio. Furthermore, the mathematical model is developed to combine the radar data of the burden profile. The above model is currently used in Nanjing Steel as a reference for operators to adjust the charging. The model is being tested with a radar system on the blast furnace.

The main trough of a blast furnace (BF) is a main passage for hot metal and molten slag transportation from the taphole to the torpedo and the slag handling. Its appropriate working status and controlled erosion ensure a safe, stable, high-efficiency and low-cost continuous production of hot metal. In this work, the tapping process of a main trough of a BF in the east of China was numerically studied with the help of a CFD library written in C++, called OpenFOAM, based on the use of the Finite Volume Method (FVM). The results show that turbulence intensity downstream of the hot metal impact position becomes weaker and the turbulence area becomes larger in the main trough. During the tapping, thermal stress of wall refractory reaches the maximum value of $1{.7\times 10}^7$ Pa at the 4 m position in the main trough. Furthermore, baffles in the main trough placed between 5.8 m and 6.2 m were found to control and reduce the impact of the turbulence on the refractory life. The metal flowrate upstream of the baffles can be decreased by 6%, and the flow velocity on the upper sidewall and bottom wall decrease by 9% and 7%, respectively, compared with the base model. By using baffles, the minimum fatigue life of the refractory in the main trough increases by 15 tappings compared with the base model, so the period between the maintenance stops can be prolonged by about 2 days.

The state of a blast furnace hearth, especially the liquid level of hot metal and slag during the tapping process, is of crucial importance with respect to a long campaign blast furnace. In practice, the state of the hearth is evaluated mainly by the experience of operators. In this paper, the electromotive force (EMF) is used to monitor the liquid level of a laboratory scale of blast furnace hearth and the effect of liquid level, EMF sensors position and the thickness of refractory on EMF signals are tested using a single layer of water and double layers of water and oil. After laboratory experiments, the electromotive force (EMF) is used to monitor the liquid level of torpedo ladle successfully. Laboratory experimental results show that the change in liquid level can be characterized by EMF signal. The state of liquid surface and local thermal state cause the EMF signal to vary in the circumferential direction of the vessel. Furthermore, the EMF signal magnitude decreases with the decrease of the thickness of the graphite crucible. Finally, the main conclusions of the laboratory experiment are supported by the torpedo ladle experiment.