Combined cycle gas turbine power plants with sequential supplementary firing in the heat recovery steam generator could be an attractive alternative for markets with access to competitive natural gas prices, with an emphasis on capital cost reduction, and where supply of carbon dioxide for Enhanced Oil Recovery (EOR) is important. Sequential combustion makes use of the excess oxygen in gas turbine exhaust gas to generate additional CO2, but, unlike in conventional supplementary firing, allows keeping gas temperatures in the heat recovery steam generator below 820°C, avoiding a step change in capital costs. It marginally decreases relative energy requirements for solvent regeneration and amine degradation. Power plant models integrated with capture and compression process models of Sequential Supplementary Firing Combined Cycle (SSFCC) gas-fired units show that the efficiency penalty is 8.2% points LHV compared to a conventional natural gas combined cycle power plant with the same capture technology. The marginal thermal efficiency of natural gas firing in the heat recovery steam generator can increase with supercritical steam generation to reduce the efficiency penalty to 5.7% points LHV. Although the efficiency is lower than the conventional configuration, the increment in the power output of the combined steam cycle leads a reduction of the number of gas turbines, at a similar power output to that of a conventional natural gas combined cycle. This has a positive impact on the number of absorbers and the capital costs of the post combustion capture plant by reducing the total volume of flue gas by half on a normalised basis. The relative reduction of overall capital costs is, respectively, 15.3% and 9.1% for the subcritical and the supercritical combined cycle configurations with capture compared to a conventional configuration. For a gas price of $2/MMBTU, the Total Revenue Requirement (TRR) – a metric combining levelised cost of electricity and revenue from EOR – of subcritical and supercritical sequential supplementary firing is consistently lower than that of a conventional NGCC by, respectively, 2.2 and 5.7 $/MWh at 0 $/t CO2 and by 4.9 and 6.7 $/MWh at $50/t CO2. At a gas price of $4/MMBTU and $6/MMBTU, the TRR of a subcritical configuration is consistently lower for any carbon selling price higher than 2.5 $/t CO2 and 37 $/t CO2 respectively
Small-scale organic Rankine cycle (ORC) systems driven by solar energy are compared in this paper, which aims to explore the potential of power generation for domestic utilisation. A solar thermal collector was used as the heat source for a hot water storage tank. Thermal performance was then evaluated in terms of both the conventional ORC and an ORC using thermal driven pump (TDP). It is established that the solar ORC using TDP has a superior performance to the conventional ORC under most working conditions. Results demonstrate that power output of the ORC using TDP ranges from 72 W to 82 W with the increase of evaporating temperature, which shows an improvement of up to 3.3% at a 100 °C evaporating temperature when compared with the power output of the conventional ORC. Energy and exergy efficiencies of the ORC using TDP increase from 11.3% to 12.6% and from 45.8% to 51.3% when the evaporating temperature increases from 75 °C to 100 °C. The efficiency of the ORC using TDP is improved by up to 3.27%. Additionally, the exergy destruction using TDP can be reduced in the evaporator and condenser. The highest exergy efficiency in the evaporator is 96.9%, an improvement of 62% in comparison with that of the conventional ORC, i.e., 59.9%. Thus, the small-scale solar ORC system using TDP is more promising for household application.