The fire retardant action of red phosphorus in nylon 6 was im proved by co-addition of ferric/ferrous oxides. It was found that the activity of Fe oxides depends on the product grade. Polymer formulations, non-ignitable in air were obtained by co-addition of Fe3O4/Fe2O3 = 3:2 with red phosphorus. Scanning electron microscopy showed that ferric oxide contributes beneficially to the fire retardancy, probably because it modifies the morphology of the char. Red phosphorus coated by Fe3O4 and encapsulated with phenol formaldehyde resin provided further improvements of fire retardancy and significantly de creased the rate of evolution of phosphine. Mechanistic studies did not support the hypothesis reported in the literature, that the fire retardant action of red phosphorus is due to its oxidation by oxygen of air.
Two new 9,10-dihydro-9-oxa-10-phosphaphenanthrene 10-oxide (DOPO)-containing compounds, (6,6′-(1-methylethylidene)-bis(9,10-dihydro-9-oxa-10-phosphaphenantrene-10-oxide)) (bis-DOPO) and 2,4,6-tris-(9,10-dihydro-9-oxa-10-phosphaphenanthrene 10-oxide)-1,3-diacetoxybenzene (DOPO-RA), were synthesized and characterized by nuclear magnetic resonance and Fourier transform infrared spectroscopy. These new flame retardants were incorporated into epoxy formulations to produce a copper-clad laminate. When fully cured, the DOPO-groups of bis-DOPO become a part of the epoxy chains, whereas the DOPO-groups of DOPO-RA remain pendant to the epoxy polymer network. Despite their higher phosphorus content, bis-DOPO-based laminates showed a poorer flame-retardant performance compared to the DOPO-RA laminates. It is believed that the pendant position of the DOPO group with respect to the polymer chains is essential for a gas-phase flame-retardant action.
In the view of many national and international human health and environmental regulations, polymeric flame retardants are sustainable products. In this work, a series of high molecular weight and polymeric brominated flame retardants are synthesized by the alkylation of aromatic molecules or the alkylation of aromatic polymers with pentabromobenzyl bromide (PBBB) or tetrabromoxylylene dibromide (TBXDB). The flame retardants prepared via the alkylation of toluene or diphenylethane with PBBB were found to be not truly polymeric but had high Mw > 1400. However, the alkylation of the same aromatic molecules by a mixture of PBBB and TBXDP resulted in polymeric flame retardants with Mw > 130,000. Two other polymeric flame retardants were prepared by the alkylation of aromatic polymers (polyphenylene ether or polystyrene) with PBBB. It was found that the new flame retardants had a high bromine content of more than 68%. They showed high thermal stability with the onset of thermal decomposition above 360 °C and a maximum rate of weight loss at about 375–410 °C. The newly synthesized flame retardants were tested in different thermoplastics. Flame retardant efficiency and physical properties were comparable or better than the reference commercial flame retardants.
Polyurethane foams encompass a wide range of materials which, depending on the foam structure, chemical composition, and presence of flame retardants, can be very combustible or fire resistant. The first commercial flame retardants for polyurethane foams were developed 60 years ago with a focus on fire retardant efficiency. These legacy flame retardants are relatively small volatile molecules that can migrate from the foam to the environment. Now the flame retardant industry has been changing with a focus on reactive or polymeric flame retardants. This article gives a short overview of these new commercial flame retardants.