We aimed to develop a process for constructing a carbon-based microelectromechanical system (MEMS). First, we prepared a highly oriented pyrolytic graphite (HOPG) crystal microsheet by exfoliation. We fabricated cantilevers and a double-clamped beam by controlling the thickness of the HOPG microsheet using a MEMS process. Second, we used a graphite sheet with contour line adhesion by metal sputter deposition. Third, we used a highly accurate graphite sheet with face adhesion and laser cutting. The first resonance frequencies were evaluated. We confirmed improvement in Q values to 1/10 level of a quarts vibrator, high performance, and a simple structure.
Stereolithography that uses a femtosecond laser was employed as a method for multiphoton-sensitized polymerization. We studied the stereolithography method, which produces duplicate solid shapes corresponding to the trajectory of the laser focus point and can be used to build a three-dimensional (3D) structure using a conductive polymer. To achieve this, we first considered a suitable polymerization condition for line stereolithography. However, this introduced a problem of irregular polymerization. To overcome this, we constructed a support in the polymerized part using a protein material. This method can stabilize polymerization, but it is not suited for building 3D shapes. Therefore, we considered whether heat accumulation causes the irregular polymerization; consequently, the reduction method of the repetition rate of the femtosecond laser was used to reduce the heating process. This method enabled stabilization and building of a 3D shape using photo-polymerization of a conductive polymer.
Tactile devices are often used in the field of robotics; however, the development of compact high-resolution tactile devices remains challenging. In this study, we developed a haptic device for force presentation using a DC motor and a tactile sensation device to simultaneously present haptic and tactile stimuli. A microelectromechanical system was selected to maintain the compactness of the tactile device. Piezoelectric micromachined ultrasonic transducers are known for high-power stimulation, and we selected lanthanum-doped lead zirconate titanate as the high-power amplified actuator. A finger mount structure that transfers force for amplifying ultrasonic waves was considered to combine acoustic pressure and aeroacoustics by attaching silicone rubber. The device was fabricated, and the performance of the tactile sensations was evaluated. The developed device uses the novel concept of combining acoustic pressure and aeroacoustics, and its compactness renders it suitable for wearable systems.
Micro-nano 3D printing of the conductive 3,4-ethylenedioxythiophene polymer (PEDOT) was performed in this study. An oil immersion objective lens was introduced into the 3D photofabrication system using a femtosecond pulsed laser as the light source. As a result, the processing resolution in the horizontal and vertical directions was improved in comparison to our previous study. A relatively high electrical conductivity (3500 S/cm) was found from the obtained 3D PEDOT micro-structures. It is noteworthy that the high conductivity of the PEDOT was obtained in the mixed state with an insulating Nafion sheet.
26 November 2008 in Journal of Computing and Information Science in Engineering