A setup for the measurement of ultrasonic properties of single crystals at high pressure in the 10 GPa range is presented. In order to validate this new device, based on the “Paris–Edinburgh” press, the elastic properties of germanium have been measured and compared with the published data. The transit times of the ultrasonic waves are directly measured. The three elastic moduli and their pressure derivatives are obtained up to 6 GPa through three different methods of calculation, which are presented and compared. These results are in good agreement with previous results and hence validate the device. The Paris–Edinburgh press enables in situ measurement of ultrasonic and x-ray diffraction on the studied sample.
Liquid cesium (l-Cs) sound velocity at high densities was investigated along a 500-K isotherm using high-pressure picosecond acoustics measurements. At 2.0 GPa, the liquid sound velocity goes through a maximum versus pressure without any change on the reflectivity and interferometry acoustic signals. Upon further compression, a softening of the l-Cs viscoelastic properties is observed from 2.0 up to 4.0 GPa, pressure at which the reflectometric signal is abruptly reversed whereas the interferometric signal remains qualitatively the same. This anomalous behavior could be related to an electronic transformation within the l-Cs state, which here again could reflect what happens at lower temperature within the solid state. If so, such liquid-liquid transition may be driven by the progressive collapse of the electronic orbital onto the ones. Above 4.0 GPa, the l-Cs sound velocity starts again to increase as commonly expected upon compression.
We describe here a time resolved pump-probe laser technique—picosecond interferometry—which has been combined with diamond anvil cells (DAC). This method enables the measurement of the longitudinal sound velocity up to Mbar pressure for any kind of material (solids, liquids, metals, insulators). We also provide a description of picosecond acoustics data analysis in order to determine the complete set of elastic constants for single crystals. To illustrate such capabilities, results are given on the pressure dependence of the acoustic properties for prototypical cases: polycrystal (hcp-Fe-5 wt% Si up to 115 GPa) and single-crystal (Si up to 10 GPa).