We combined a spin resolved photoemission spectrometer with a high-harmonic generation (HHG) laser source in order to perform spin, time, and angle resolved photoemission spectroscopy (STARPES) experiments on the transition metal dichalcogenide bulk , a possible Weyl type-II semimetal. Measurements at different femtosecond pump-probe delays and comparison with spin resolved one-step photoemission calculations provide insight into the spin polarization of electrons above the Fermi level in the region where Weyl points of are expected. We observe a spin accumulation above the Weyl points region, which is consistent with a spin-selective bottleneck effect due to the presence of spin-polarized conelike electronic structure. Our results support the feasibility of STARPES with HHG, which despite being experimentally challenging provides a unique way to study spin dynamics in photoemission.
The dosing of layered materials with alkali metals has become a commonly used strategy in ARPES experiments. However, precisely what occurs under such conditions, both structurally and electronically, has remained a matter of debate. Here we perform a systematic study of 1T-, a prototypical semimetal of the transition metal dichalcogenide family. By utilizing photon energy-dependent angle-resolved photoemission spectroscopy (ARPES), we have investigated the electronic structure of this material as a function of potassium (K) deposition. From the maps, we observe the appearance of 2D dispersive bands after electron dosing, with an increasing sharpness of the bands, consistent with the wave-function confinement at the topmost layer. In our highest-dosing cases, a monolayerlike electronic structure emerges, presumably as a result of intercalation of the alkali metal. Here, by bringing the topmost valence band below , we can directly measure a band overlap of eV. However, 3D bulklike states still contribute to the spectra even after considerable dosing. Our work provides a reference point for the increasingly popular studies of the alkali metal dosing of semimetals using ARPES.
We performed spin-, time- and angle-resolved extreme ultraviolet photoemission spectroscopy of excitons prepared by photoexcitation of inversion-symmetric with circularly polarized light. The very short probing depth of XUV photoemission permits selective measurement of photoelectrons originating from the top-most layer, allowing for direct measurement of hidden spin polarization of bright and momentum-forbidden dark excitons. Our results reveal efficient chiroptical control of bright excitons’ hidden spin polarization. Following optical photoexcitation, intervalley scattering between nonequivalent valleys leads to a decay of bright excitons’ hidden spin polarization. Conversely, the ultrafast formation of momentum-forbidden dark excitons acts as a local spin polarization reservoir, which could be used for spin injection in van der Waals heterostructures involving multilayer transition metal dichalcogenides.
18 January 2019 in Acta crystallographica Section B, Structural science, crystal engineering and materials
Cobalt ferrite ultrathin films with the inverse spinel structure are among the best candidates for spin filtering at room temperature. High-quality epitaxial CoFe2O4 films about 4 nm thick have been fabricated on Ag(001) following a three-step method: an ultrathin metallic CoFe2 alloy was first grown in coherent epitaxy on the substrate and then treated twice with O2, first at room temperature and then during annealing. The epitaxial orientation and the surface, interface and film structure were resolved using a combination of low-energy electron diffraction, scanning tunnelling microscopy, Auger electron spectroscopy and in situ grazing-incidence X-ray diffraction. A slight tetragonal distortion was observed, which should drive the easy magnetization axis in-plane due to the large magneto-elastic coupling of such a material. The so-called inversion parameter, i.e. the Co fraction occupying octahedral sites in the ferrite spinel structure, is a key element for its spin-dependent electronic gap. It was obtained through in situ resonant X-ray diffraction measurements collected at both the Co and Fe K edges. The data analysis was performed using FDMNES, an ab initio program already extensively used to simulate X-ray absorption spectroscopy, and shows that the Co ions are predominantly located on octahedral sites with an inversion parameter of 0.88 (5). Ex situ X-ray photoelectron spectroscopy gives an estimation in accordance with the values obtained through diffraction analysis.
The growth of Bi on both the In-terminated (A) face and the As-terminated (B) face of InAs(1 1 1) has been investigated by low-energy electron diffraction, scanning tunnelling microscopy, and photoelectron spectroscopy using synchrotron radiation. The changes upon Bi deposition of the In 4d and Bi 5d5/2 photoelectron signals allow to get a comprehensive picture of the Bi/InAs(1 1 1) interface. From the early stage the Bi growth on the A face is epitaxial, contrary to that on the B face that proceeds via the formation of islands. Angle-resolved photoelectron spectra show that the electronic structure of a Bi deposit of ≈10 bi-layers on the A face is identical to that of bulk Bi, while more than ≈30 bi-layers are needed for the B face. Both bulk and surface electronic states observed are well accounted for by fully relativistic ab initio calculations performed using the one-step model of photoemission. These calculations are used to analyse the dichroic photoemission data recorded in the vicinity of the Fermi level around the point of the Brillouin zone.
26 April 2019 in Journal of Physics: Condensed Matter
The goal of the present review is to cross-compare theoretical predictions with selected experimental results on bismuth thin films exhibiting topological properties and a strong Rashba effect. The theoretical prediction that a single free-standing Bi(1 1 1) bilayer is a topological insulator has triggered a large series of studies of ultrathin Bi(1 1 1) films grown on various substrates. Using selected examples we review theoretical predictions of atomic and electronic structure of Bi thin films exhibiting topological properties due to interaction with a substrate. We also survey experimental signatures of topological surface states and Rashba effect, as obtained mostly by angle- and spin-resolved photoelectron spectroscopy.