In this paper, a super-hydrophobic cotton fabric was fabricated by low-pressure plasma-enhanced chemical vapor enhanced deposition (LP-PECVD) with lauryl methacrylate (LMA) as the functional monomer. Scanning electron microscopy (SEM), atomic force microscope (AFM) and X-ray photoelectron spectroscopy were used to analyze the changes of surface morphology and chemical composition of the cotton fabrics surface, respectively. A randomly wrinkled morphology was exhibited by SEM and AFM. The combination of the low surface energy film of LMA and micro-nano-scale structure resulted in the super-hydrophobicity of modified cotton fabrics. The reactive species in LMA/Ar plasma were studied by optical emission spectroscopy, and based on the results of the test, the reaction principle in the plasma reaction chamber was discussed. It was proved that the LMA film is polymerized by chemical bonds on the surface of cotton fibers. The water repellency, washing stability, water-vapor transmission, air permeability and tensile property of fabrics were also discussed. We found that a washing-stable and breathable super-hydrophobic cotton fabric can be achieved after treatment without decreasing the tensile property.
During the processes of production, storage, transportation and use of hazardous chemicals, acid–alkali corrosive liquid spatter and leakage would cause serious casualties. In order to protect the lives and health of staff, the surface of fabrics should be treated to obtain hydrophobicity and acid–alkali resistance. In this paper, polyester fabric was used as the base cloth, and polydimethylsiloxane (PDMS) and polytetrafluoroethylene (PTFE) micro-powder were used as the functional materials to fabricate waterproof and breathable fabric with good acid–alkali resistance using a method of plasma pretreatment-impregnation- and plasma-induced crosslinking. The effects of PDMS, PTFE powder and plasma-induced crosslinking on the surface and physical and chemical properties of fabric were investigated. It was found that the use of PDMS and PTFE powder had little effect on the mechanical and wearing comfort properties. However, it could significantly improve the acid–alkali resistance, as the liquid repellent rate of the treated fabric surface was higher than 80%, and the penetration index was lower than 2%.
In this paper, stable super-hydrophobic lauryl methacrylate (LMA) film on the surface of cotton fabrics was fabricated by a simple process of pulsed plasma-enhanced chemical vapor deposition (PECVD) with different duty cycles. The influence of duty cycles on the surface structure and properties of cotton fabrics was analyzed after a series of measurements. The results showed that water contact angles (WCAs) of samples were inversely proportional to the duty cycle values and exhibited the highest WCA (162°) at a duty cycle of 2%. The optimized washing durability of samples was obtained under the treatment of duty cycle of 25% and the WCA could still reach 127° after 15 laundering cycles. The formation of a micro-nano-composite structure and evenness of film could be observed by atomic force microscopy and scanning electron microscopy. Nevertheless, the sample, which was treated by plasma with a 25% duty cycle, had the best uniformity of film deposition. The results of attenuated total reflection Fourier transform infrared spectroscopy and X-ray photoelectron spectroscopy illustrated that the LMA monomer was grafted and deposited on the surface of cotton fabrics successfully in covalent binding after PECVD treatment, and this was supposed to be the cause of the washing stability of the films. The results indicated that cotton fabrics modified with the proposed method can exhibit excellent super-hydrophobicity and washing durability, while the duty cycle was an appreciable effect factor in the modification.