This paper presents a sub-electron temporal readout noise, 8.3 Mpixel and 1.1-μm pixel pitch 3-D-stacked CMOS image sensor (CIS). A conditional correlated multiple sampling (CMS) technique is introduced to selectively reduce the dark pixel noise by using a full-range ramp and a small-range ramp. In this way, a sub-electron temporal readout noise CIS is achieved without degrading the frame rate dramatically, compared to the conventional CMS method. A column-parallel single slope ADC with dark pixel detection function is proposed as well. A dynamic-dark-signal-region detection technique is used to mitigate differential nonlinearity (DNL) errors due to ramp slope mismatch. The implemented prototype in 45-nm CIS/65-nm CMOS occupies an area of 35.89 mm². This paper achieves a 0.66e-rms with 5-time sampling at a frame rate of 7.2 frames/s, which corresponds to a sample-rate frequency of 36.1 kHz for the column ADC. The DNL (11 b) is improved from +0.98 LSB/-0.94 LSB to +0.29 LSB/-0.39 LSB by using dynamic dark-signal region technique. The figure of merit of this paper is 2.02 nVrms/Hz.
This paper presents a high dynamic range (DR) linear-logarithmic (Lin-Log) CMOS image sensor (CIS) pixel with threshold voltage cancellation technique for pixel fixed pattern noise (PFPN) reduction. A tunable pixel response curve was applied for different environments. To avoid the gain loss of source follower in conventional APS structure, a column shared-amplifier with programmable gain was also applied. A prototype high DR Lin-Log CIS chip consisting of 100 × 100 5-T pixel array with n+/p-sub photodiode, a pixel area of 6 × 6 μm2, and 3.3 V operation was designed and fabricated in TSMC 0.18 μm CMOS 1P6M standard process. The measured results achieved a DR of 143 dB, a PFPN related to sensitivity in logarithmic response (rms/log-sensitivity) of 1.96%, and a PFPN related to full-swing in logarithmic response (rms/Vlog-swing) of 0.45%. Linear and logarithmic sensitivity were 651 mV/lux-s and 55 mV per decade of illumination, respectively, at 50 fps. The temporal noise and power consumption were 0.746 m Vrms and 1.88 mW, respectively.
In this paper we present a systematic approach to sort out different types of random telegraph noises (RTN) in CMOS image sensors (CIS) by examining their dependencies on the transfer gate off-voltage, the reset gate off-voltage, the photodiode integration time, and the sense node charge retention time. Besides the well-known source follower RTN, we have identified the RTN caused by varying photodiode dark current, transfer-gate and reset-gate induced sense node leakage. These four types of RTN and the dark signal shot noises dominate the noise distribution tails of CIS and non-CIS chips under test, either with or without X-ray irradiation. The effect of correlated multiple sampling (CMS) on noise reduction is studied and a theoretical model is developed to account for the measurement results.
A study of the random telegraph noise (RTN) of a 1.1 μm pitch, 8.3 Mpixel CMOS image sensor (CIS) fabricated in a 45 nm backside-illumination (BSI) technology is presented in this paper. A noise decomposition scheme is used to pinpoint the noise source. The long tail of the random noise (RN) distribution is directly linked to the RTN from the pixel source follower (SF). The full 8.3 Mpixels are classified into four categories according to the observed RTN histogram peaks. A theoretical formula describing the RTN as a function of the time difference between the two phases of the correlated double sampling (CDS) is derived and validated by measured data. An on-chip time constant extraction method is developed and applied to the RTN analysis. The effects of readout circuit bandwidth on the settling ratios of the RTN histograms are investigated and successfully accounted for in a simulation using a RTN behavior model.
This paper proposes a novel single-slope (SS) ADC design and operation for full well capacity (FWC) expansion of CMOS image sensor to increase the dynamic range for small pixel. With the proposed technique, charges stored in the photodiode and floating diffusion of 4T active pixel sensor are all read out and accumulated by the proposed SS ADC to improve the FWC. Only one A/D conversion is required for each pixel, which decreases chip power consumption compared with the general double A/D conversion operation. A 160×140 CMOS image sensor chip with the proposed SS ADC is fabricated using 0.18-μm CMOS image sensors technology. This chip achieves a sensitivity of 5.33 V/lx·s and a FWC expansion ratio of 2.18 at 38.5 fps. The measured FWC is 47.45 ke- with 118% boost. The ADC resolution is 8 bits and the resulting differential nonlinearity/integral nonlinearity of proposed column-parallel SS ADC is (+0.16,-0.24)/(+0.28,-0.52) least significant bit. The column-fixed pattern noise is 0.16%.
Slow-motion video is a desirable feature for state-of-art smartphones. The effect is achieved by capturing a video at a higher frame rate and playing it back at a lower frame rate. While the still-image resolution of smartphone cameras ranges from 8MP to 25MP, standard videos are limited to 3 formats: 3840×2160 (4K2K, 2160p), 1920×1080 (Full High Definition, FHD, 1080p), and 1280×720 (High Definition, HD, 720p). CMOS image sensors using various column-parallel aDc architectures have been reported to reach high frame rates [1-5]. The single-slope (SS) ADC is an attractive choice for a balanced performance among high speed, low noise, small area, and low power consumption. However, in conventional SS ADC design, each ADC is hardwired to a column signal line. ADCs for skipped columns are left idle during the subsampling operation, and the potential to reach higher frame rate is not optimized. In this paper, we develop an approach in which all the column ADCs are fully utilized in both of the 2-to-1 and 3-to-1 subsampling modes, such that the maximum of 4x faster FHD and 9x faster HD videos are demonstrated with reference to the 1-to-1 non-subsampled 4K2K video.