Al–Cr–N coatings were formed at various nitrogen pressures, substrate bias voltages and substrate temperatures using cathodic arc evaporation. The relationship between technological parameters and properties of the coatings was investigated. The phase and chemical composition of the coatings, roughness, hardness, adhesion and thermal stability were analyzed by X-ray diffraction (XRD), scanning electron microscope (SEM), Energy-dispersive X-ray spectroscopy (EDX), micro-indenter, Rockwell, scratch tester and thermomechanical methods. The corrosion resistance of selected coatings was also investigated. XRD analysis indicates that the coatings crystallize in a cubic structure and show preferential orientation (200) CrN. With the increase of nitrogen pressure, the preferential orientation changes to (111). EDX analysis shows that as nitrogen pressure increases, the Al/(Al + Cr) rate decreases. Microscopic observations indicate that the number of macroparticles reduces as nitrogen pressure increases. As a result, the surface roughness parameter Ra of the coatings decreases. The effects of deposition temperature, nitrogen pressure and substrate bias voltage on the mechanical and tribological properties of the coatings were investigated. It was found that the above parameters influence the mechanical properties in different ways. The hardness and adhesion of coatings formed at higher temperatures was lower. Coatings formed under a higher nitrogen pressure or substrate bias voltage were characterized by higher hardness and better wear resistance.
We investigated the spectral properties of light-emitting diodes based on a deep blue-emitting pyrazoloquinoline dye doped into a poly( -vinylcarbazole)-based matrix. Even though the electroluminescence (EL) of the host is redshifted and broadened with respect to the emission of the dye, the EL spectrum becomes fully dominated by the dye emission at concentrations of ca. . This is attributed to a competition of exciplex formation on the matrix and exciton formation on the dye.
The current market requirements are related to the introduction of new protective coatings for tools and machine parts with much better performance properties. These requirements are met by the AlCrSiN coatings; however, knowledge on the adhesion of these coatings to the substrate, as well as on their corrosion resistance, is deficient. The article presents the results of technological works on the coating deposition from AlCrSi cathodes with a silicon concentration from 0 at% to 10 at% by the cathodic arc evaporation and the results of systematic studies of their structure, mechanical, tribological and electrochemical properties. A correlation between the above-mentioned properties and the silicon concentration in the AlCrSiN coatings has been found and discussed. The coatings formed from cathodes containing less than 5 at% Si crystallize in the cubic structure. The size of the crystallites decreases with the silicon concentration increase. The coatings are characterized by a high hardness with a maximum of about 37 GPa (2 at% Si). The adhesion of the coatings is almost independent of the concentration of silicon. The wear rate is about one order of magnitude higher for coatings deposited from cathodes with a silicon concentration of 5 at% and 10 at% compared to a coating with a lower silicon concentration. This finding is consistent with the results of corrosion resistance studies. The coating deposited from the cathode with 10 at% of silicon exhibits the best anticorrosion properties against the salt solution.