The accurate state of charge (SOC) estimation of the LiFePO₄ battery packs used in robot applications is required for better battery life cycle, performance, reliability, and economic issues. In this paper, a new SOC estimation method, “Modified ECE + EKF”, is proposed. The method is the combination of the modified Equivalent Coulombic Efficiency (ECE) method and the Extended Kalman Filter (EKF) method. It is based on the zero-state hysteresis battery model, and adopts the EKF method to correct the initial value used in the Ah counting method. Experimental results show that the proposed technique is superior to the traditional techniques, such as ECE + EKF and ECE + Unscented Kalman Filter (UKF), and the accuracy of estimation is within 1%.

This paper presents a novel parasitic-insensitive switched-capacitor (PISC) sensing circuit design in order to obtain high sensitivity and ultra linearity and reduce the parasitic effect for the out-of-plane single-gimbaled decoupled CMOS-MEMS gyroscope (SGDG). According to the simulation results, the proposed PISC circuit has better sensitivity and high linearity in a wide dynamic range. Experimental results also show a better performance. In addition, the PISC circuit can use signal processing to cancel the offset and noise. Thus, this circuit is very suitable for gyroscope measurement.

This paper presents a novel CMOS wireless temperature sensor design in order to improve the sensitivity and linearity of our previous work on such devices. Based on the principle of CMOS double zero temperature coefficient (DZTC) points, a combined device is first created at the chip level with two voltage references, one current reference, and one temperature sensor. It was successfully fabricated using the 0.35 μm CMOS process. According to the chip results in a wide temperature range from −20 °C to 120 °C, two voltage references can provide temperature-stable outputs of 823 mV and 1,265 mV with maximum deviations of 0.2 mV and 8.9 mV, respectively. The result for the current reference gives a measurement of 23.5 µA, with a maximum deviation of 1.2 µA. The measurements also show that the wireless temperature sensor has good sensitivity of 9.55 mV/°C and high linearity of 97%. The proposed temperature sensor has 4.15-times better sensitivity than the previous design. Moreover, to facilitate temperature data collection, standard wireless data transmission is chosen; therefore, an 8-bit successive-approximation-register (SAR) analog-to-digital converter (ADC) and a 433 MHz wireless transmitter are also integrated in this chip. Sensing data from different places can be collected remotely avoiding the need for complex wire lines.