Membrane distillation technology, as a new membrane-based water treatment technology that combines the membrane technology and evaporation process, has the advantages of using low-grade heat, working at atmospheric pressure with simple configuration, etc. In this study, heat and mass transfer were coupled at the membrane surfaces through the user-defined function program. The effects of feed temperature, feed velocity and permeate velocity on temperature polarization were mainly investigated for a high-concentration NaCl solution. The temperature polarization was increased with the increase of feed temperature and the decrease of feed and permeate velocity. The effects of temperature, inlet velocity and solution concentration on the evaporation efficiency of the membrane module for co- and counter-current operations were investigated in detail. The counter-current operation performed better than co-current operation in most cases, except for the condition where the NaCl concentration was relatively low or the module length was long enough. In addition, the optimal membrane thickness for both PVDF and PTFE was studied. The optimal membrane thickness was found in the range of 10 to 20 μm, which corresponded to the highest permeate flux for the selected materials, pore size distribution, and operation conditions. Membrane material with lower thermal conductivity and larger porosity was prone to get higher permeate flux and had larger optimal membrane thickness. Increasing feed velocity or feed temperature could decrease the optimal membrane thickness.
Nanoencapsulated phase change materials (NePCMs) are promising thermal energy storage (TES) and heat transfer materials that show great potential in battery thermal management systems (BTMSs). In this work, nanocapsules with a paraffin core and silica shell were prepared using an optimized sol-gel method. The samples were characterized by different methods regarding chemical composition, thermal properties, etc. Then, the nanocapsules were used as the coolant by mixing with insulation oil in the immersion cooling of a simulative battery. The sample doped with Ag on the shell with a core-to-shell ratio of 1:1 showed the best performance. Compared to the sample without doping material, the thermal conductivity increased by 49%, while the supercooling degree was reduced by 35.6%. The average temperature of the simulative battery cooled by nanocapsule slurries decreased by up to 3.95 °C compared to the test performed with pure insulation oil as the coolant. These novel nanocapsules show great potential in the immersion cooling of a battery.