All‐solid‐state batteries with an alkali metal anode have the potential to achieve high energy density. However, the onset of dendrite formation limits the maximum plating current density across the solid electrolyte and prevents fast charging. It is shown that the maximum plating current density is related to the interfacial resistance between the solid electrolyte and the metal anode. Due to their high ionic conductivity, low electronic conductivity, and stability against sodium metal, Na‐β″‐alumina ceramics are excellent candidates as electrolytes for room‐temperature all‐solid‐state batteries. Here, it is demonstrated that a heat treatment of Na‐β″‐alumina ceramics in argon atmosphere enables an interfacial resistance <10 Ω cm2 and current densities up to 12 mA cm−2 at room temperature. The current density obtained for Na‐β″‐alumina is ten times higher than that measured on a garnet‐type Li7La3Zr2O12 electrolyte under equivalent conditions. X‐ray photoelectron spectroscopy shows that eliminating hydroxyl groups and carbon contaminations at the interface between Na‐β″‐alumina and sodium metal is key to reach such values. By comparing the temperature‐dependent stripping/plating behavior of Na‐β″‐alumina and Li7La3Zr2O12, the role of the alkali metal in governing interface kinetics is discussed. This study provides new insights into dendrite formation and paves the way for fast‐charging all‐solid‐state batteries.
15 February 2018 in ACS Sustainable Chemistry & Engineering
The transition from fossil fuels to renewable energy sources requires economic, high‐performance electrochemical energy storage. High‐temperature sodium‐metal chloride batteries combine long cycle and calendar life, with high specific energy, no self‐discharge, and minimum maintenance requirements, while employing abundant raw materials. However, large‐scale deployment in mobility and stationary storage applications is currently hindered by high production cost of the complex, commercial tubular cells and limited rate capability. The present study introduces sodium‐metal chloride cells with a simple, planar architecture that provide high specific power while maintaining the inherent high specific energy. Rational cathode design, considering critical transport processes and the effect of cathode composition on the cell resistance, enables the development of high‐performance cells with average discharge power of 1022 W kg−1 and discharge energy per cycle of 258 Wh kg−1 on cathode composite level, shown over 140 cycles at an areal capacity of 50 mAh cm−2. This corresponds to a 3.2C discharge over 80% of full charge. Compared to the best performing planar sodium‐metal chloride cells with similar cycling stability and mass loading in the literature, the presented performance represents an increase in specific power by more than a factor of four, while also raising the specific energy by 74%.