In this work, the SCAPS-1D program was utilized to perform simulations of ZnO/CuO/Cu 2 O thin-film solar cells. Based on the cell structure and device fabrication process, solar cell structure parameters such as the thickness of the CuO layer, ZnO layer, donor density in the ZnO layer were evaluated in detail. The results indicated that an optimal structure of ZnO/CuO/Cu 2 O thin-film solar cell could be obtained when the thickness of the ZnO layer, CuO layer, and donor density in the ZnO layer is 100 nm, 500 nm, 1 × 10 17 cm −3 , respectively. The optimized solar cell structure of ZnO/CuO/Cu 2 O shows a potential efficiency of about 12% under the 1 sun air mass 1.5 G spectrum illumination. Besides that, the performance of the cell under individual solar concentrations and operating temperatures was also investigated.
The photocatalytic activity of the ZnO NRs/CuO composite film was investigated by using both experimental and numerical methods. The ZnO NRs/CuO composite film exhibits significantly enlarge absorption range to visible-light and suppress the recombination rate of the photogenerated electron-hole pairs, which can be well utilized as a photocatalyst. The ZnO NRs/CuO composite film also presents good stability, and reusability, and durability for photo-decomposition purpose. The optimal ZnO NRs/CuO composite film contains 1μ-thick of CuO film and 10 nm-thick of ZnO NRs film. The donor concentration in ZnO NRs film should be lower than 1016 cm−3. The short circuit current density of the optimal composite film is 25.8 mA/cm2 resulting in the calculated pseudo-order rate constant of 1.85 s−1. The enhancement in degradation efficiency of this composite film is attributed to the inner electric field and large effective surface area of ZnO NRs film.
We report on the influence of shell addition, shell thickness, and shape of CdSe/ZnSe/ZnS colloidal quantum dots (QDs) on luminescence, decay lifetime, and photoblinking. The addition of shell layers appreciably increased (decreased) the time interval of on (off) time, while the increase of outer shell thickness only increases the time interval of on-time. The photoblinking was suppressed as the QD shape changes from spherical to ellipsoidal probably due to the reduction of Auger process as the wave function degeneracy of the identical states of the two holes is lifted. We also suggest that interface traps might enhance the Auger recombination.
Radial junction solar cells with vertically aligned wire arrays have been widely studied to improve the power conversion efficiency. In this work, we report the first Ge nanopillar solar cell. Nanopillar arrays are selectively patterned on p-type Ge (100) substrates using nanosphere lithography and deep reactive ion etching processes. Nanoscale radial and planar junctions are realized by an n-type Ge emitter layer which is epitaxially grown by MOCVD using isobutylgermane.In situepitaxial surface passivation is employed using an InGaP layer to avoid high surface recombination rates and Fermi level pinning. High quality n-ohmic contact is realized by protecting the top contact area during the nanopillar patterning. The short circuit current density and the power conversion efficiency of the Ge nanopillar solar cell are demonstrated to be improved up to 18 and 30%, respectively, compared to those of the Ge solar cell with a planar surface.