The daily (24 h) averages of the aerosol radiative forcing (ARF) at the surface and the top of the atmosphere (TOA) were calculated during desert dust events over Granada (southeastern Spain) from 2005 to 2010. A radiative transfer model (SBDART) was utilized to simulate the solar irradiance values (0.31–2.8 μm) at the surface and TOA, using as input aerosol properties retrieved from CIMEL sun photometer measurements via an inversion methodology that uses the sky radiance measurements in principal plane configuration and a spheroid particle shape approximation. This inversion methodology was checked by means of simulated data from aerosol models, and the derived aerosol properties were satisfactorily compared against well-known AERONET products. Good agreement was found over a common spectral interval (0.2–4.0 μm) between the simulated SBDART global irradiances at surface and those provided by AERONET. In addition, simulated SBDART solar global irradiances at the surface have been successfully validated against CM-11 pyranometer measurements. The comparison indicates that the radiative transfer model slightly overestimates (mean bias of 3%) the experimental solar global irradiance. These results show that the aerosol optical properties used to estimate ARF represent appropriately the aerosol properties observed during desert dust outbreak over the study area. The ARF mean monthly values computed during desert dust events ranged from −13 ± 8 W m⁻² to −34 ± 15 W m⁻² at surface, from −4 ± 3 W m⁻² to −13 ± 7 W m⁻² at TOA and from +6 ± 4 to +21 ± 12 W m⁻² in the atmosphere. We have checked if the differences found in aerosol optical properties among desert dust sectors translate to differences in ARF. The mean ARF at surface (TOA) were −20 ± 12 (−5 ± 5) W m⁻², −21 ± 9 (−7 ± 5) W m⁻² and −18 ± 9 (−6 ± 5) W m⁻² for sector A (northern Morocco; northwestern Algeria), sector B (western Sahara, northwestern Mauritania and southwestern Algeria), and sector C (eastern Algeria, Tunisia), respectively. The Kolmogorov-Smirnov statistical test revealed that daily {ARF} values at TOA for sector A were significantly different from the other two sectors, likely as a result of the lower values of single scattering albedo obtained for sector A. The mean values of aerosol radiative forcing efficiency at surface (TOA) were −74 ± 12 W m⁻² (−17 ± 7 W m⁻²) for sector A, −70 ± 14 W m⁻² (−20 ± 9 W m⁻²) for sector B, and −65 ± 16 W m⁻² (−22 ± 10 W m⁻²) for sector C, and thus comparable between the three sectors in all seasons.

A new methodology based on combining active and passive remote sensing and simultaneous and collocated radiosounding data to study the aerosol hygroscopic growth effects on the particle optical and microphysical properties is presented. The identification of hygroscopic growth situations combines the analysis of multispectral aerosol particle backscatter coefficient and particle linear depolarization ratio with thermodynamic profiling of the atmospheric column. We analyzed the hygroscopic growth effects on aerosol properties, namely the aerosol particle backscatter coefficient and the volume concentration profiles, using data gathered at Granada EARLINET station. Two study cases, corresponding to different aerosol loads and different aerosol types, are used for illustrating the potential of this methodology. Values of the aerosol particle backscatter coefficient enhancement factors range from 2.1 ± 0.8 to 3.9 ± 1.5, in the ranges of relative humidity 60–90 and 40–83%, being similar to those previously reported in the literature. Differences in the enhancement factor are directly linked to the composition of the atmospheric aerosol. The largest value of the aerosol particle backscatter coefficient enhancement factor corresponds to the presence of sulphate and marine particles that are more affected by hygroscopic growth. On the contrary, the lowest value of the enhancement factor corresponds to an aerosol mixture containing sulphates and slight traces of mineral dust. The Hänel parameterization is applied to these case studies, obtaining results within the range of values reported in previous studies, with values of the γ exponent of 0.56 ± 0.01 (for anthropogenic particles slightly influenced by mineral dust) and 1.07 ± 0.01 (for the situation dominated by anthropogenic particles), showing the convenience of this remote sensing approach for the study of hygroscopic effects of the atmospheric aerosol under ambient unperturbed conditions. For the first time, the retrieval of the volume concentration profiles for these cases using the Lidar Radiometer Inversion Code (LIRIC) allows us to analyze the aerosol hygroscopic growth effects on aerosol volume concentration, observing a stronger increase of the fine mode volume concentration with increasing relative humidity.

The main goal of this study is to analyze the dependence of columnar aerosol optical and microphysical properties on source region and transport pathways during desert dust intrusions over Granada (Spain) from January 2005 to December 2010. Columnar aerosol properties have been derived from a non‐spherical inversion code using the solar extinction measurements and sky radiances in the principal plane. Two classification methods of the African air masses ending at the study location were used by means of the HYSPLIT back‐trajectories analysis. The first one, based on desert dust origin sources, discriminated the optical properties only for sector B (corresponding to western Sahara, northwest Mauritania and southwest Algeria). The particles present marked absorbing properties (low value of single scattering albedo at all wavelengths) during the desert dust events when the air masses were transported from sector A (north Morocco, northwest Algeria). This result may be related to the mixing of desert dust with anthropogenic pollutants from North African industrial areas in addition to the mixing with local anthropogenic aerosol and pollutants transported from European and Mediterranean areas. The second classification method was based on a statistics technique called cluster classification which allows grouping the air masses back trajectories with similar speed and direction of the trajectory. This method showed slight differences in the optical properties between the several transport pathways of air masses. High values of the aerosol optical depth and low mean values of the Angström parameter were associated with longer transport pathways over desert dust sources and slowly moving air masses. Both classification methods showed that the fine mode was mixed with coarse mode, being the fine mode fraction smaller than 55%.

Measurements on 27 June 2011 were performed over the Southern Iberian Peninsula at Granada EARLINET station, using active and passive remote sensing and airborne and surface in-situ data in order to study the entrainment processes between aerosols in the free troposphere and those in the planetary boundary layer (PBL). To this aim the temporal evolution of the lidar depolarisation, backscatter-related Angström exponent and potential temperature profiles were used in combination with the PBL contribution to the aerosol optical depth (AOD). Our results show that the mineral dust entrainment in the PBL was caused by the convective processes which ‘trapped’ the lofted mineral dust layer, distributing the mineral dust particles within the PBL. The temporal evolution of ground-based in-situ data evidenced the impact of this process at surface level. Finally, the amount of mineral dust in the atmospheric column available to be dispersed into the PBL was estimated by means of POLIPHON (Polarizing Lidar Photometer...

LIRIC (Lidar‐Radiometer Inversion Code) is applied to combined lidar and Sun photometer data from Granada station corresponding to different case studies. The main aim of this analysis is to evaluate the stability of LIRIC output volume concentration profiles for different aerosol types, loadings, and vertical distributions of the atmospheric aerosols. For this purpose, in a first part, three case studies corresponding to different atmospheric situations are analyzed to study the influence of the user‐defined input parameters in LIRIC when varied in a reasonable range. Results evidence the capabilities of LIRIC to retrieve vertical profiles of microphysical properties during daytime by the combination of the lidar and the Sun photometer systems in an automatic and self‐consistent way. However, spurious values may be obtained in the lidar incomplete overlap region depending on the structure of the aerosol layers. In a second part, the use of a second Sun photometer located in Cerro Poyos, in the same atmospheric column as Granada but at higher altitude, allowed us to obtain LIRIC retrievals from two different altitudes with independent Sun photometer measurements in order to check the self‐consistency and robustness of the method. Retrievals at both levels are compared, providing a very good agreement (differences below 5 µm³/cm³) in those cases with the same aerosol type in the whole atmospheric column. However, some assumptions such as the height independency of parameters (sphericity, size distribution, or refractive index, among others) need to be carefully reviewed for those cases with the presence of aerosol layers corresponding to different types of atmospheric aerosols.