Aims. State‐of‐the‐art bioaerosol samplers have poor collection efficiencies for ultrafine virus aerosols. This work evaluated the performance of a nove

Development of an air quality monitoring network with high spatio-temporal resolution requires installation of a large number of air pollutant monitors. However, state-of-the-art monitors are costly and may not be compatible with wireless data logging systems. In this study, low-cost electro-chemical sensors manufactured by Alphasense Ltd. for detection of CO and oxidative gases (predominantly O₃ and NO₂) were evaluated. The voltages from three oxidative gas sensors and three CO sensors were recorded every 2.5 sec when exposed to controlled gas concentrations in a 0.125-m³ acrylic glass chamber. Electro-chemical sensors for detection of oxidative gases demonstrated sensitivity to both NO₂ and O₃ with similar voltages recorded when exposed to equivalent environmental concentrations of NO₂ or O₃ gases, when evaluated separately. There was a strong linear relationship between the recorded voltages and target concentrations of oxidative gases (R² > 0.98) over a wide range of concentrations. Although a strong linear relationship was also observed for CO concentrations below 12 ppm, a saturation effect was observed wherein the voltage only changes minimally for higher CO concentrations (12–50 ppm). The nonlinear behavior of the CO sensors implied their unsuitability for environments where high CO concentrations are expected. Using a manufacturer-supplied shroud, sensors were tested at 2 different flow rates (0.25 and 0.5 Lpm) to mimic field calibration of the sensors with zero air and a span gas concentration (2 ppm NO2 or 15 ppm CO). As with all electrochemical sensors, the tested devices were subject to drift with a bias up to 20% after 9 months of continuous operation. Alphasense CO sensors were found to be a proper choice for occupational and environmental CO monitoring with maximum concentration of 12 ppm, especially due to the field-ready calibration capability. Alphasense oxidative gas sensors are usable only if it is valuable to know the sum of the NO₂ and O₃ concentrations.

Objective: To determine the effect of an acute (1 week) and chronic (3 weeks) exposure to E-cigarette (E-cig) emissions on mucociliary clearance (MCC) in murine lungs. Methods: C57BL/6 male mice (age 10.5 ± 2.4 weeks) were exposed for 20 min/day to E-cigarette aerosol generated by a Joyetech 510-T^® E-cig containing either 0% nicotine (N)/propylene glycol (PG) for 1 week (n = 6), or 3 weeks (n = 9), or 2.4% N/PG for one week (n = 6), or 3 weeks (n = 9), followed by measurement of MCC. Control mice (n = 15) were not exposed to PG alone, or N/PG. MCC was assessed by gamma camera following aspiration of ^99mtechnetium aerosol and was expressed as the amount of radioactivity removed from both lungs over 6 hours (MCC6hrs). Venous blood was assayed for cotinine levels in control mice and in mice exposed for 3-weeks to PG alone and N/PG. Results: MCC6hrs in control mice and in mice acutely exposed to PG alone and N/PG was similar, averaging (±1 standard deviation) 8.6 ± 5.2%, 7.5 ± 2.8% and 11.2 ± 5.9%, respectively. In contrast, chronic exposure to PG alone stimulated MCC6hrs (17.2 ± 8.0)% and this stimulation was significantly blunted following chronic exposure to N/PG (8.7 ± 4.6)% (p < .05). Serum cotinine levels were <0.5 ng/ml in control mice and in mice exposed to PG alone, whereas, N/PG exposed mice averaged 14.6 ± 12.0 ng/ml. Conclusions: In this murine model, a chronic, daily, 20 min-exposure to N/PG, but not an acute exposure, slowed MCC, compared to exposure to PG alone and led to systemic absorption of nicotine.