This study examines the structure and properties of stainless steel coatings deposited to incorporate large concentrations of nitrogen along with varying amounts of titanium. Deposition was carried out using magnetron co-sputtering of stainless steel and titanium from separate targets in a mixed Ar/N2 gas atmosphere. Composition analysis by X-ray photoelectron spectroscopy showed that while films with up to 4 at.% Ti exhibited little change in nitrogen content (compared to films deposited without Ti) and remained sub-stoichiometric with respect to N content. Films with 7–8 at.% Ti had a higher N level and further increasing the Ti level to 11–12 at.% resulted in stoichiometric N levels. X-ray diffraction showed that the films all had a nominally FCC structure with no additional phases. However, the peak locations for the (111) and (200) reflections indicated a distorted lattice characteristic of the S-phase, with calculated c/a values ranging from 1.007 to 1.033. The Ti additions, along with the corresponding increase in N content, helped reduce the extent of lattice distortion. The film microstructure of the higher (11–12 at.%) Ti films also showed higher density, lower surface roughness, and a finer grain structure. As a result, these films had a higher hardness compared to the sub-stoichiometric films, with hardness levels in the range of 18–23 GPa, typical of transition metal nitrides coatings.
Welcome to Lubricants, a new open access journal for researchers and practitioners working in the field of tribology. The journal will publish peer-reviewed research papers, reviews, letters and communications, as well as papers on research ideas and proposals. The concept of open access is exciting because it allows free access of all publications to anyone, resulting in the widest dissemination possible for the authors publishing in the journal. In addition, publication is rapid, and full use can be made of color figures which are published at no additional cost to the authors. The contents of the journal will nonetheless be archival and articles can therefore have a long-term impact.
29 November 2012 in Journal of Materials Engineering and Performance