A demonstration test with the aim to show the potential of ammonia-fired power plant is planned using a micro gas turbine. 50kW class turbine system firing kerosene is selected as a base model. A standard combustor is replaced by a prototype combustor which enables a bi fuel supply of kerosene and ammonia gas. Diffusion combustion is employed in the prototype combustor due to its flame stability. Demonstration test of co-firing of kerosene and ammonia gas was achieved to check the functionality of the each component of the micro gas turbine. The gas turbine started firing kerosene and increased its electric power output. After achievement of stable power output, ammonia gas was started to be supplied and its flow rate increased gradually. 21kW power generation was achieved with 30% decrease of kerosene by supplying ammonia gas. Ammonia gas supply increases NOx in the exhaust gas dramatically. However post-combustion clean-up of the exhaust gas via SCR can reduce NOx successfully.
A feedback control system for mitigating flow separation was developed by using a string-type dielectric-barrier-discharge (DBD) plasma actuator and a fiber Bragg grating (FBG) sensor. Tangential jets were induced from the string-type DBD plasma actuator, which was located at 5% chord from the leading edge of an NACA0024 airfoil. The FBG sensor was attached to the interior surface near the root of the cantilever beam modeled on the pressure surface of the airfoil. The strain at the cantilever root was reflected in the form of Bragg wavelengths () detected by the FBG sensor when the cantilever tip was vibrated by the flow near the trailing edge of the airfoil. It was found that calculating running standard deviations in the Bragg wavelength () detected by the sensor was valuable for judging flow separation in real time. The feedback control of flow separation on the NACA0024 airfoil was successfully demonstrated by setting with periodic flow separations generated in a wind tunnel by oscillating a side wall of the test section with frequency Hz. It was confirmed that the appearance probability of flow separation tends to decrease with a decrease in the duration for calculating and with an increase in the duration of jet injection.
24 February 2023 in Aerospace Science and Technology