Electrically insulating and thermally conductive polymer matrix composites are desirable for industry applications as they improve the reliability of high-performance electronic devices, particularly via heat dissipation in devices loaded with several electronic components. In this study, an aggregated β-Si3N4 filler with randomly oriented grains was produced via combustion synthesis to improve the thermal conductivity of epoxy composites. The thermal conductivities of the prepared composites were investigated as a function of the filler content, and the values were compared to those of composites loaded with commercial β-Si3N4 (non-aggregated). Negligible difference was observed in the thermal conductivities of both types of composites when the Si3N4 content was below 40 vol%; however, above 40 vol%, the aggregated β-Si3N4 filler-loaded composites showed higher thermal conductivities than the commercial β-Si3N4-loaded composites. The aggregated β-Si3N4 filler-loaded composites exhibited isotropic thermal conductivities with a maximum value of 4.7 W m−1 K−1 at 53 vol% filler content, which is approximately 2.4 times higher than that of the commercial β-Si3N4-loaded composites, thereby suggesting that the morphology of the aggregated filler would be more efficient than that of the commonly used non-aggregated filler in enhancing the thermal conductivity of a polymer matrix composite.
Aluminum nitride (AlN) usually exhibits a microstructure consisting of equiaxed grains. However, these grains do not allow for the positive control of the microstructure and mechanical properties of AlN. In this work, we attempted to control the microstructure of AlN through the addition of whiskers and investigated the relationship between the microstructure and mechanical properties. The sintered AlN showed a microstructure consisting of large, rod-like grains, which originated from the whiskers. Furthermore, the microstructure varied with the size and amount of whiskers added, and so did the flexural strength and fracture toughness. The flexural strength and fracture toughness of the whisker-added AlN samples ranged from 197 to 267 MPa and 5.4 to 6.4 MPa m1/2, respectively. In contrast, those of AlN without whiskers were 336 MPa and 3.1 MPa m1/2, respectively.
30 October 2015 in Journal of the American Ceramic Society
The effect of the thermal conductivity of ceramic compact on the porous structure of a foamed body formed by the direct foaming process was investigated. In order to change the thermal conductivity of the ceramic compact, three types of ceramic powder (alumina, mullite, and cordierite) with different particle sizes were used. These ceramic powders were mixed with powdered resol resin, which is a foamable thermoset resin used as both a foaming agent and binder for the ceramic powders. Ceramic compacts were prepared from the mixed starting ceramic and resol powders by press molding, and then characterized by thermal conductivity. The foamed bodies were produced from the ceramic compacts by heating to the resol foaming temperature to produce porous structures. The pore structures of the foamed bodies were strongly affected by differences in thermal conductivity in the ceramic compacts.
1 January 2017 in Journal of the Ceramic Society of Japan