A 3D Computational Particle Fluid Dynamic (CPFD) model is validated against experimental measurements in a lab-scale cold flow model of a Circulating Fluidized Bed (CFB). The model prediction of pressure along the riser, downcomer and siphon as well as bed material circulation rates agree well with experimental measurements. Primary and secondary air feed positions were simulated by varying the positions along the height of the reactor to get optimum bed material circulation rate. The optimal ratio of the height of primary and secondary air feed positions to the total height of the riser are 0.125 and 0.375 respectively. The model is simulated for high-temperature conditions and for reacting flow including combustion reactions. At the high temperature and reaction conditions, the bed material circulation rate is decreased with the corresponding decrease in pressure drop throughout the CFB for the given air feed rate
Here is information on how to publish, spread your research, and search for your publications. Most of LiU's research publications are directly imported into DiVA from the Web of Science. Before registering a publication, always check if the publication is already in DiVA!
The efficiency of a fluidized bed reactor depends on the bed fluid dynamic behavior, which is significantly influenced by the bubble properties. This work investigates the bubble properties of a bubbling fluidized bed reactor using computational particle fluid dynamic (CPFD) simulations and electrical capacitance tomography (ECT) measurements. The two-dimensional images (along the reactor horizontal and vertical planes) of the fluidized bed are obtained from the CPFD simulations at different operating conditions. The CPFD model was developed in a commercial CPFD software Barracuda Virtual Reactor 20.0.1. The bubble behavior and bed fluidization behavior are characterized form the bubble properties: average bubble diameter, bubble rise velocity, and bubble frequency. The bubble properties were determined by processing the extracted images with script developed in MATLAB. The CPFD simulation results are compared with experimental data (obtained from the ECT sensors) and correlations in the literature. The results from the CPFD model and experimental measurement depicted that the average bubble diameter increased with an increase in superficial gas velocities up to and decreased with a further increase in gas velocities due to the onset of large bubbles (potential slugging regime). The bubble rise velocity increased as it moved from the lower region to the bed surface. The Fourier transform of the transient solid volume fraction illustrated that multiple bubbles pass the plane with varying amplitude and frequency in the range of 1–6 Hz. Further, the bubble frequency increased with an increase in superficial gas velocity up to and decreased with a further increase in gas velocity. The CPFD model and method employed in this work can be useful for studying the influence of bubble properties on conversion efficiency of a gasification reactor operating at high temperatures.
1 June 2016 in International Journal of Modeling and Optimization