More than 50% of the energy released through combustion in the internal combustion engine (ICE) is rejected to the environment. Recovering only a part of this energy can significantly improve the overall use of resources and the economic efficiency of road transport. One solution to recoup a part of this otherwise wasted thermal energy is to use thermoelectric generator (TEG) modules for the conversion of heat directly into electricity. To aid in development of this technology, this effort covers the derivation of a respectively simple steady-state Simulink model that can be utilized to estimate and optimize TEG system performance for ICEs. The model was validated against experimental data found in literature utilizing water cooling for the cold side. Overall, relatively good agreement was found with the maximum error in generated power around 10%. Following, it was investigated whether air can be used as a cooling medium. It was established that, at the same temperature as the water (18.4 °C), a flow velocity of 13.1 m/s (or 47.2 km/h) is required to achieve a similar cold junction temperature and power output. Subsequently using the model with air cooling, the performance of a TEG installed on a heavy-duty vehicle traveling at 50, 80, 90, and 120 km/h under different ambient temperatures was analyzed. It was determined that both a lower temperature and a higher flow velocity can improve power output. A further increase of the power output requires a larger temperature gradient across the module, which can be achieved by a higher heat input on the hot side.

This paper provides a comprehensive review of the development, deployment and challenges of Intelligent Transport Systems (ITSs) in Europe. Driven by the EU Directive 2010/40/EU, the deployment of ITSs has become essential for improving the safety, efficiency and sustainability of transport. The study examines how ITS technologies, such as automation, real-time traffic data analytics and vehicle-to-vehicle (V2V) and vehicle-to-infrastructure (V2I) communication, have been integrated to improve urban mobility and road safety. In addition, it reviews significant European initiatives and case studies from several cities, which show visible improvements in reducing congestion, reducing CO₂ emissions and increasing the use of public transport. The paper highlights, despite progress, major obstacles to widespread adoption, such as technical interoperability, inadequate regulatory frameworks and insufficient data sharing between stakeholders. These issues prevent ITS applications from scaling up and functioning well in EU Member States. To overcome these problems, the study highlights the need for common standards and cooperation frameworks. The research analyses the laws, technological developments and socio-economic effects of ITSs. By promoting sustainable and inclusive mobility, ITSs can contribute to the European Green Deal and climate goals. Finally, the paper presents ITSs as a revolutionary solution for future European transport systems and offers suggestions to improve their interoperability, data governance and policy support.

In this paper the effects of an experimental bioethanol fumigation application using an experimental ultrasound device on performance and emissions of a single cylinder diesel engine have been experimentally investigated. Engine performance and pollutant emissions variations were considered for three different types of fuels (biodiesel, biodiesel-bioethanol blend and biodiesel and fumigated bioethanol). Reductions in brake specific fuel consumption and NOx pollutant emissions are correlated with the use of ultrasonic fumigation of bioethanol fuel, comparative to use of biodiesel-bioethanol blend. Considering the fuel consumption as diesel engine?s main performance parameter, the proposed bioethanol?s fumigation method, offers the possibility to use more efficient renewable biofuels (bioethanol), with immediate effects on environmental protection.

In this paper is presented a crash simulation analysis of the battery pack in order to increase the stiffness when the electric vehicle is involved in traffic accidents. In the first part is presented the state of the art, highlighting the advantages of using electric vehicles. The second part of the study presents the steps required to create the crash analysis of the battery pack. The CAD design of the assembly model is generated using advanced modelling techniques for two simulations battery pack models: the first model has a basic shape geometry and the second model has a shock absorber mounted on the external faces to reduce the crash impact. The crash analysis of the battery pack is determined for three velocity cases: 7 m/s, 14 m/s and 21 m/s. The final part of the paper presents the simulation results and different advantages of the battery pack geometry with the shock absorber.