Microstructure evolution of Ag–28Cu–1Ni alloy during the continuous casting process was simulated based on 3D-CAFE method, and the effect of the mean nucleation undercooling and the distance from the bottom of the ingot to the cross section on the solidification structure were studied. Furthermore, the effects of pouring temperature, heat transfer coefficient and pulling speed on solidification structure were also investigated. The results show that the simulated results are in agreement with the experimental results. The solidification structure consists of four parts, including region of surface fine grain, zone of columnar grain, transition zone of CET (columnar to equiaxed grain transition) and region of center equiaxed grain. The higher the mean undercooling, the larger the columnar dendrite zone. The ΔTv,max = 5 K is determined as an important simulation parameter to simulate the microstructure evolution. As the cross-section increases from the bottom of the ingot, the columnar crystal regions gradually expand. Moreover, lowering the pouring temperature, increasing the heat transfer coefficient or improving the pulling speed have the beneficial effect on grain refinement. Under the optimal process conditions, the largest proportion of equiaxed grains and the finer grain size is present in the solidified structure.
1 January 2020 in Materials Science and Technology
The temperature field, flow field and solidification structure of Ag–28Cu–2Ge–0.4Co alloy during solidification under water cooling, air cooling and slow cooling conditions were investigated, respectively. The results indicate that the temperature distribution is the most uniform and the solid–liquid phase region is the widest under slow cooling condition. The temperature gradient at the solidification front is the largest under water cooling condition. The solidification rate increases with the distance away from the sidewall under three cooling conditions. Under water-cooled conditions, the liquid flow at the front of the liquidus is much smaller than that in the other two conditions. The ratio of equiaxed crystals and columnar crystals in the solidified structure is different under different cooling conditions.