The present study investigates Mg (0 ÷ 17.5 wt %), Cu (0 ÷ 21 wt %) and Ni (0 ÷ 20.2 wt %) dopants (M-doped) influence on photocatalytic activity of amorphous TiO2 thin films. Magnetron sputtering was used for the deposition of M-doped TiO2 thin films. According to SEM/EDS surface analysis, the magnetron sputtering technique allows making M-doped TiO2 thin films with high uniformity and high dopant dispersion. Photocatalysis efficiency analysis was set in oxalic acid under UV irradiation. In accordance with the TOC (total organic carbon) measurements followed by the apparent rate constant (kapp) results, the dopants’ concentration peak value was dopant-dependent; for Mg/TiO2, it is 0.9% (kapp—0.01866 cm−1), for Cu/TiO2, it is 0.6% (kapp—0.02221 cm−1), and for Ni/TiO2, it is 0.5% (kapp—0.01317 cm−1). The obtained results clearly state that a concentration of dopants in TiO2 between 0.1% and 0.9% results in optimal photocatalytic activity.
The formation of Ag nanoparticles on the surface of TiO2 (AgNP/TiO2) to enhance photocatalytic efficiency was studied. The Ag nanoparticles (AgNP) size, form, and distribution dependence on the initial thickness of Ag thin films, annealing temperature, and time were analyzed. The optimal annealing temperature of 400 °C and annealing time of 60 min were chosen to form AgNP from the initial Ag thin films with a thickness of 5, 7.5, and 10 nm. The formation of AgNP was done on amorphous TiO2 (a-TiO2), which crystallized into the anatase phase after the annealing. The photocatalytic efficiency (k–degradation rate constant, Defi–degradation efficiency) was evaluated by the photodegradation of Rhodamine B aqueous solution. The results suggested that the highest photocatalytic efficiency of Rhodamine B aqueous solution was reached where the average diameter (DA) of AgNP was ~38 nm (k38 = 0.017 min−1, Defi_38 = 63.5%), compared to 27 and 82 nm (k27 = 0.012 min−1, Defi_27 = 51.2% and k82 = 0.011 min−1, Defi_82 = 52.1%, respectively). The acquired results did not show clear correlation between the size and distribution of the AgNP on the TiO2 surface and photocatalytic efficiency. Nevertheless, the results suggest that AgNP can enhance the photocatalytic efficiency of TiO2 thin films (kTiO2 = 0.008 min−1, Defi_TiO2 = 36.3%).
1 January 2021 in ECS Journal of Solid State Science and Technology
The conduction band discontinuity between n-type Si substrates and anatase TiO 2 films has been investigated. n-type Si substrates with three different dopant concentrations were used as a substrate for TiO 2 thin-films: N D = 10 15–16 cm −3 (as n-Si); N D = 10 17–18 cm −3 (as n + -Si); N D = 10 20–21 cm −3 (as n ++ -Si). The translation of X-ray photoelectron spectroscopy (XPS) results to an energy band diagram through the valence band offset (VBO) enables us to evaluate the conduction band discontinuities accurately: n-Si/TiO 2 —−0.22 eV, n + -Si/TiO 2 —−0.06 eV, and n ++ -Si/TiO 2 —+0.07 eV. Temperature–dependent current–voltage (I–V) characteristics were measured to evaluate the Fermi energy level (E F ) of the TiO 2 thin-films. Light transmittance was measured to evaluate the energy bandgap of the TiO 2 thin-films. The band diagram of the n-type Si/TiO 2 heterojunction was proposed. Deep-insight analysis of n-type Si/TiO 2 was carried out on the basis of measured I–V characteristics.
A TiO 2 /Si hybrid photoelectrode (HPE) (photoanode) consisting of TiO 2 and a Si n ++ p ++ nn ++ photoelectrode, and a Pt-free counter photoelectrode (photocathode) consisting of Au or Ag clusters and a Si n ++ pp ++ junction were manufactured and investigated. TiO 2 was deposited on the Si n ++ p ++ nn ++ photoelectrode to widen the spectral selectivity from UV to visible light. The alternative Pt-free counter photoelectrodes were manufactured with a slightly different structure, where Au or Ag clusters were deposited on the n ++ layer of the Si n ++ pp ++ junction. The photocurrent of the Si n ++ p ++ nn ++ photoelectrode and the TiO 2 /Si HPE was measured using the Pt electrode or the Pt-free counter photoelectrodes. The analysis was carried out in the dark and under low-intensity UV light irradiation. The TiO 2 /Si HPE with the Pt-free counter photoelectrode (Ag clusters/Si n ++ p ++ nn ++ junction) showed an increase of up to 74.2% in photocurrent compared with the Pt counter electrode. A deep-insight analysis for the new and simple design of the promising TiO 2 /Si HPE and the Pt-free counter photoelectrodes for hydrogen evolution from water was carried out.