Methane activation chemistry, despite being widely reported in literature, remains to date a subject of debate. The challenges in this reaction are not limited to methane activation but extend to stabilization of the intermediate species. The low C-H dissociation energy of intermediates vs. reactants leads to CO2 formation. For selective oxidation, nature presents methane monooxygenase as a benchmark. This enzyme selectively consumes methane by breaking it down into methanol. To assemble an active site similar to monooxygenase, the literature reports Cu-ZSM-5, Fe-ZSM-5, and Cu-MOR, using zeolites and systems like CeO2/Cu2O/Cu. However, the trade-off between methane activation and methanol selectivity remains a challenge. Density functional theory (DFT) calculations and spectroscopic studies indicate catalyst reducibility, oxygen mobility, and water as co-feed as primary factors that can assist in enabling higher selectivity. The use of chemical looping can further improve selectivity. However, in all systems, improvements in productivity per cycle are required in order to meet the economical/industrial standards.
Palladium membranes are considered ideal for high purity hydrogen separation owing to their infinite selectivity to hydrogen. The key to such selectivity depends on the dense surface of the membrane that suggests absolute non-porous surface morphology. However, preparation of dense palladium membranes irrespective of any deposition technique leads to pit formation which makes synthesis of dense palladium membrane challenging. The current study illustrates the application of electroless plating assisted with novel catalytic sol pre-coating to prepare dense Pd membranes. The surface characterization using field emission scanning electron microscope (FESEM) and atomic force microscopy (AFM) were performed to identify the gaps between dip coating and electroless plating. It was observed that with the use of a dip coated catalytic sol, thinner and well dispersed Pd deposits could be prepared. The porosity of deposited Pd layers does not affect the essential densification property as sol surface underneath dispersed Pd remains dense.