Hyphenation of electrochemistry and mass spectrometry is an attractive method to investigate oxidation and reduction processes. By using mass spectrometry, electrochemically generated products can be identified. In this Review, different approaches to electrochemistry–mass spectrometry will be summarized, including hyphenation of electrochemical flow cells to mass spectrometry as well as integration of separation steps between electrochemical reactions and detection of products. Fields of application range from bioanalytical studies to studies regarding corrosion, electrosynthesis and energy carriers. Important historical developments will be highlighted, followed by an overview of terminology and instrumental setups and discussion of developments within recent years (2017–2020).
Reduced graphene oxide (rGO) was investigated as a material for use in chemiresistive gas sensors. The carbon nanomaterial was transferred onto a silicon wafer with interdigital gold electrodes. Spin coating turned out to be the most reliable transfer technique, resulting in consistent rGO layers of reproducible quality. Fast changes in the electrical resistance at a low operating temperature of 85 °C could be detected for the gases NO 2 , CH 4 and H 2 . Especially upon adsorption of NO 2 the high signal changes allowed a minimum detection of 0.3 ppm ( S / N = 3). To overcome the poor selectivity, rGO was chemically functionalized with octadecylamine, or modified by doping with metal nanoparticles such as Pd and Pt, and also metal oxides such as MnO 2 , and TiO 2 . The different response patterns for six different materials allowed the discrimination of all of the test gases by pattern recognition based on principal component analysis.
Successful transfer of photoacoustic gas sensors from laboratory to real-life applications requires knowledge about potential cross-sensitivities towards environmental and gas matrix changes. Multi-dimensional calibration in case of cross-sensitivities can become very complex or even unfeasible. To address this challenge, we present a novel algorithm to compute the collision based non-radiative efficiency and phase lag of energy relaxation on a molecular level (CoNRad) for photoacoustic signal calculation. This algorithmic approach allows to calculate the entire relaxation cascade of arbitrarily complex systems, yielding a theoretical photoacoustic signal. In this work the influence of varying bulk compositions, i.e. nitrogen (N2), oxygen (O2) and water (H2O) on the photoacoustic signal during methane (CH4) detection is demonstrated. The applicability of the algorithm to other photoacoustic setups is shown exemplary by applying it to the relaxational system investigated in [1]. Hayden et al. examined the effect of water on photoacoustic carbon monoxide (CO) detection.