Cellulase enzymes have been reported to contribute with a significant share of the total costs and greenhouse gas emissions of lignocellulosic ethanol production today. A potential future alternative to purchasing enzymes from an off-site manufacturer is to integrate enzyme and ethanol production, using microorganisms and part of the lignocellulosic material as feedstock for enzymes. This study modelled two such integrated process designs for ethanol from logging residues from spruce production, and compared it to an off-site case based on existing data regarding purchased enzymes. Greenhouse gas emissions and primary energy balances were studied in a life-cycle assessment, and cost performance in a techno-economic analysis. The base case scenario suggests that greenhouse gas emissions per MJ of ethanol could be significantly lower in the integrated cases than in the off-site case. However, the difference between the integrated and off-site cases is reduced with alternative assumptions regarding enzyme dosage and the environmental impact of the purchased enzymes. The comparison of primary energy balances did not show any significant difference between the cases. The minimum ethanol selling price, to reach break-even costs, was from 0.568 to 0.622 EUR L−1 for the integrated cases, as compared to 0.581 EUR L−1 for the off-site case. An integrated process design could reduce greenhouse gas emissions from lignocellulose-based ethanol production, and the cost of an integrated process could be comparable to purchasing enzymes produced off-site. This study focused on the environmental and economic assessment of an integrated process, and in order to strengthen the comparison to the off-site case, more detailed and updated data regarding industrial off-site enzyme production are especially important.
The production of biogas from six agricultural crops was analysed regarding energy efficiency and greenhouse gas (GHG) performance for vehicle fuel from a field-to-tank perspective, with focus on critical parameters and on calculation methods. The energy efficiency varied from 35% to 44%, expressed as primary energy input per energy unit vehicle gas produced. The GHG reduction varied from 70% to 120%, compared with fossil liquid fuels, when the GHG credit of the digestate produced was included through system expansion according to the calculation methodology in the ISO 14044 standard of life cycle assessment. Ley crop-based biogas systems led to the highest GHG reduction, due to the significant soil carbon accumulation, followed by maize, wheat, hemp, triticale and sugar beet. Critical parameters are biogenic nitrous oxide emissions from crop cultivation, for which specific emission factors for digestate are missing today, and methane leakage from biogas production. The GHG benefits were reduced and the interrelation between the crops changed, when the GHG calculations were instead based on the methodology stated in the EU Renewable Energy Directive, where crop contribution to soil carbon accumulation is disregarded. All systems could still reach a 60% GHG reduction, due to the improved agricultural management when digestate replaces mineral fertilisers.
Whilst life cycle assessment (LCA) boundaries are expanded to account for negative indirect consequences of bioenergy such as indirect land use change (ILUC), ecosystem services such as water purification sometimes delivered by perennial bioenergy crops are typically neglected in LCA studies. Consequential LCA was applied to evaluate the significance of nutrient interception and retention on the environmental balance of unfertilised energy willow planted on 50-m riparian buffer strips and drainage filtration zones in the Skåne region of Sweden. Excluding possible ILUC effects and considering oil heat substitution, strategically planted filter willow can achieve net global warming potential (GWP) and eutrophication potential (EP) savings of up to 11.9 Mg CO2e and 47 kg PO4e ha−1 year−1, respectively, compared with a GWP saving of 14.8 Mg CO2e ha−1 year−1 and an EP increase of 7 kg PO4e ha−1 year−1 for fertilised willow. Planting willow on appropriate buffer and filter zones throughout Skåne could avoid 626 Mg year−1 PO4e nutrient loading to waters.
A greenhouse gas (GHG) emission reduction obligation system has been implemented in the Swedish road transport sector to promote the use of biofuels. For transportation fuel suppliers to fulfil this obligation, the volume of biofuel required decreases with decreasing life cycle GHG emission for the biofuel, linking lower GHG emission to higher economic value. The aim of this study was to investigate how the economic competitiveness of a Swedish emerging lignocellulosic-based ethanol production system would be influenced by the reduction obligation. The life cycle GHG emission for sawdust-based ethanol was calculated by applying the method advocated in the EU Renewable Energy Directive (RED II). The saving in GHG emissions, compared with fossil liquid transportation fuels, was 93% for a potential commercial production system in southern Sweden. This, in turn, will increase the competitiveness of sawdust-based ethanol compared to the mainly crop-based ethanol currently used in the Swedish biofuel system, which has an average GHG emission saving of 68%, and will allow for an almost 40% higher price of sawdust-based ethanol, compared to the current price of ethanol at point of import. In a future developed, large-scale market of advanced ethanol, today’s GHG emission reduction obligation system in Sweden seems to afford sufficient economic advantage to make lignocellulosic ethanol economically viable. However, in a short-term perspective, emerging lignocellulosic-based ethanol production systems are burdened with economic risks and therefore need additional economic incentives to make a market introduction possible.
This case study investigates the potentials, greenhouse gas (GHG), and energy performance of forest residue biofuels produced by new and emerging production technologies, which are commercially implemented in Sweden for heavy transport. The biofuel options included are ethanol (ED 95), hydro-processed vegetable oil (HVO), and liquefied biogas (LBG) produced from logging residues in forestry and sawdust generated in sawmills. The calculated life cycle GHG emissions, based on the EU Renewable Energy Directive calculation methodology, for all three pathways are in the range of 6–11 g CO2eq./MJ, corresponding to 88–94% GHG emission reductions as compared to fossil fuel. Critical parameters are the enzyme configuration for ethanol, hydrogen supply systems and bio-oil technology for HVO, and gasifier size for LBG. The energy input is ranging from 0.16 to 0.43 MJ/MJ biofuel and the total conversion efficiency from the feedstock to biofuel, including high-value by-products (excluding heat), varies between 61 and 65%. The study concludes that the domestic biofuel potential from estimated accessible logging residues and sawdust is equivalent to 50–100% of the current use of fossil diesel in heavy-duty road transport in Sweden, depending on the biofuel production technology selected and excluding energy by-products. Thus, an expansion of forest-based biofuels is a promising strategy to meet the ambitious climate goals in the transport sector in Sweden.