Traffic light recognition is an indispensable elemental technology for automated driving in urban areas. In this study, we propose an algorithm that recognizes traffic lights and arrow lights by image processing using the digital map and precise vehicle pose which is estimated by a localization module. The use of a digital map allows the determination of a region-of-interest in an image to reduce the computational cost and false detection. In addition, this study develops an algorithm to recognize arrow lights using relative positions of traffic lights, and the arrow light is used as prior spatial information. This allows for the recognition of distant arrow lights that are difficult for humans to see clearly. Experiments were conducted to evaluate the recognition performance of the proposed method and to verify if it matches the performance required for automated driving. Quantitative evaluations indicate that the proposed method achieved 91.8% and 56.7% of the average f-value for traffic lights and arrow lights, respectively. It was confirmed that the arrow-light detection could recognize small arrow objects even if their size was smaller than 10 pixels. The verification experiments indicate that the performance of the proposed method meets the necessary requirements for smooth acceleration or deceleration at intersections in automated driving.
2 January 2021 in Theoretical Issues in Ergonomics Science
To improve workability, designing the work environment by considering physical workload can be effective. This paper proposes a new quantitative evaluation method of physical workload during work behavior, which uses quaternion and joint torque ratio. As an indicator of physical workload, the proposed method calculated a dimensionless value based on joint rotation angle, joint rotation axis angle, and joint torque ratio. Joint rotation angle and joint rotation axis angle are angle changes in the joint and its rotational axis from those in the previous sampling, respectively. These angles were calculated using quaternions. Joint torque ratio was calculated using a three-dimensional rigid link model that simulates the human body. The applicability of the proposed method was examined in several conditions of manual handling tasks set by varying the initial pose of the work object. In the experiments, posture and electromyogram (EMG) of the upper limb were measured. The results showed that the proposed method can evaluate workability of initial orientation of work objects on biomechanical perspective, whereas EMG could not.