Diler KATIRCIOGLU-BAYEL

Diler KATIRCIOGLU-BAYEL

orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 September 2018 in Mining, Metallurgy & Exploration
Verified
Journal Article
Closed access
PDF file
DKDiler KATIRCIOGLU-BAYEL
Diler KATIRCIOGLU-BAYEL
ŞÖŞafak Gökhan Özkan
Şafak Gökhan Özkan
OTOner Yusuf Toraman
Oner Yusuf Toraman

9 March 2020 in Minerals
Verified
Journal Article
Open access
PDF file
DKDiler KATIRCIOGLU-BAYEL
Diler KATIRCIOGLU-BAYEL
The optimization of the operating parameters of a stirred media mill in the dry grinding of calcite was investigated. A three-level Box-Behnken design was used for the purpose of examining the impact of four independent factors, the stirrer speed (SS), grinding time (GT), media filling ratio (MFR), and solid mass fraction (SMF), on the product particle size (d50). For the purpose of establishing an empirical correlation between operating parameters and responses, a series of experiments were carried out. Variance analysis showed a reasonably good value for d50 (R2 = 0.965). According to the software solutions, the optimum conditions for minimizing the d50 size were found to be 573 rpm stirrer speed, 11.18 min grinding time, 63% media filling ratio, and 11.52% solid mass fraction, with 3.78 µm for the d50 size. To verify the improvement of grinding, verification tests were performed using the above-mentioned optimum conditions and the average d50 size and standard deviation were found to be 3.83 µm and 0.025, respectively. The average d50 value obtained was smaller than those obtained in the 27 tests. Furthermore, when the optimum result obtained from the experiments was compared with the result obtained using the software, a 22% energy saving was achieved. The impacts of grinding on the structural characteristics of calcite particles were characterized by XRD analysis. XRD measurements indicated that no change was observed in the peak areas of ground calcite specimens compared to the untreated calcite specimen.


12 August 2020 in Mining, Metallurgy & Exploration
Verified
Journal Article
Closed access
PDF file
DKDiler KATIRCIOGLU-BAYEL
Diler KATIRCIOGLU-BAYEL

31 December 2018 in Ömer Halisdemir Üniversitesi Mühendislik Bilimleri Dergisi
Verified
Journal Article
Open access
PDF file
DKDiler KATIRCIOGLU-BAYEL
Diler KATIRCIOGLU-BAYEL
The necessity of using flame retardant fillers or making several flame retardancy process in every area that needs heat and flame protection has become important again nowadays. For many people, the word filler is associated with cost reduction, but in recent years it has become more widely recognized that fillers modify all properties of the material in which they are mixed. Most commonly, fillers are used to assist processing and to upgrade the mechanical properties of the host polymer. In this research, it is emphasized the mineral based flame retardants and their effects.

16 July 2019 in Mining, Metallurgy & Exploration
Verified
Journal Article
Closed access
PDF file
DKDiler KATIRCIOGLU-BAYEL
Diler KATIRCIOGLU-BAYEL