Wastewater irrigation for vegetable cultivation is greatly concerned about the presence of toxic metals in irrigated soil and vegetables which causes possible threats to human health. This study aimed to ascertain the accumulation of heavy metals (HMs) in edible parts of vegetables irrigated with different stages of textile dyeing wastewater (TDW). Bio-concentration factor (BCF), Estimated daily intake (EDI), and target hazard quotient (THQ) were computed to estimate human health risks and speculate the hazard index (HI) of adults and children with the consumption of HMs contaminated vegetables at recommended doses. Five vegetables (red amaranth, Indian spinach, cauliflower, tomato, and radish) in a pot experiment were irrigated with groundwater (T1) and seven stages of TDW (T2∼T8) following a randomized complete block design (RCBD) with three replications. Among the TDW stages, T8, T7, T4, and T5 exhibited elevated BCF, EDI, THQ, and HI due to a rising trend in the accumulation of Pb, Cd, Cr, and Ni heavy metals in the edible portion of the red amaranth, followed by radish, Indian spinach, cauliflower, and tomato. The general patterns of heavy metal (HM) accumulation, regarded as vital nutrients for plants, were detected in the following sequence: Zn > Mn/Cu > Fe. Conversely, toxic metals were found to be Cd/Cr > Ni > Pb, regardless of the type of vegetables. Principal Component Analysis (PCA) identified T8, T7, and T4 of TDW as the primary contributors to the accumulation of heavy metals in the vegetables examined. Furthermore, the analysis of the heavy metals revealed that the BCF, THQ, and HI values for all studied metals were below 1, except for Pb. This suggests that the present consumption rates of different leafy and non-leafy vegetables, whether consumed individually or together, provide a low risk in terms of heavy metal exposure. Nevertheless, the consumption of T8, T7, and T4 irrigated vegetables, specifically Indian spinach alone or in combination with red amaranth and radish, by both adults and children, at the recommended rate, was found to pose potential health risks. On the other hand, T2, T3, and T6 irrigated vegetables were deemed safe for consumption. These findings indicated that the practice of irrigating the vegetables with T8, T7, and T4 stages of TDW has resulted in a significant buildup of heavy metals in the soils and edible parts of vegetables which are posing health risks to adults and children. Hence, it is imperative to discharge the T8, T7, and T4 stages of TDW after ETP to prevent the contamination of vegetables and mitigate potential health risks.

Reuse of wastewater for vegetable cultivation is becoming popular in order to augment the inadequate irrigation supplies and meet the growing demands of ground water for agriculture and industries production in different regions of the world. This study was investigated to optimize different stages of textile dyeing wastewater (TDW) for irrigation focusing on their effect on growth, yield and physiochemical attributes of tomato, plant nutrient use, heavy metals enrichment and pollution load of the irrigated soil. Textile wastewater were collected from the seven stages of (second wash after scouring and bleaching T2; enzyme treated water T3; second wash after bath drain T4; neutralization treatment T5; second wash after soaping T6; fixing treatment water T7; mixed effluent T8) of a dyeing process for physiochemical characterization and evaluation their irrigation feasibility for tomato cultivation in compare with the ground water (T1). The pot experiment consists of eight irrigation treatments was laid out following a completely randomized block design with three replications. Results showed the presence of plant nutrients and heavy metals in all the studied samples where T8 (mixed effluent) exceeded the limit of agricultural standard for almost all physiological parameters such as TDS, TSS, EC, BOD, COD affording the highest value. T8 also delivered the highest Cl- and heavy metals like Cd, Ni, Cr followed by T4 < T7. As a consequence, these provided comparatively higher enrichment factor (EF), pollution load index (PLI) and sodium absorption ratio (SAR) to transform fresh soil into the category of severe and slightly to moderate saline. Therefore, the yield and physiochemical attributes of tomato were dramatically reduced with T8 and T4 treatment. On the other hand, T2, T3 and T6 treatment had significant positive impact on growth and yield of tomato due to having higher N, P, K, S and lower heavy metals (Cu, Zn, Fe, Pb, Cd, Ni, Cr) than the recommended guideline. These features were contributed to cause minimum EF and PLI in the soil irrigated with T2, T3 and T6 stages of TDW. Correlation matrix demonstrated that EF and PLI of heavy metals (except Cd, Ni) were negatively related to yield, while positively related to SAR and fruit abortion. Although T6 (2nd wash after soaping) performed better in respect to growth, yield, yield attributes and nutrient use efficiency, principal component analysis revealed that T2 (2nd wash after scouring and bleaching) and T3 (enzyme treated water) were also belong to the same group of T6 and T1 (ground water). Thus, it may be suggested that T2, T3 and T6 stages of textile dyeing wastewater could be used profitably without ETP for vegetable cultivation and would effectively supplement not only the nutrient requirement of the crop but may also act as the alternate source of irrigation water. Although, further research is needed to sort out the health risk assessment through the heavy metals’ accumulation in the plant parts after irrigation with different stages of textile dyeing wastewater.

Carrot is a seasonal perishable tuberous root vegetable which presents a preservation challenge owing to its elevated moisture content. Recently, carrot processing has received more attention because of its many health-promoting qualities and the reduction of postharvest losses in a cost-effective safe way. This study was designed to sort out the effective solar drying technique including pre-treatment that would retain the color and quality characteristics of dehydrated carrot. Carrot slices were subjected to dry using open sun drying (D1), solar drying long chimney (D2), solar drying short chimney (D3) and box solar drying (D4) techniques with the pretreatments of ascorbic acid 1 % (C3), citric acid 5 % (C4), potassium metabisulfite 1 % (C5) and potassium sodium tartrate 0.3 % (C6) before drying. Drying characteristics, nutritional attributes, phytochemicals and antioxidant of the dehydrated carrot samples were compared with the fresh sample and untreated (control) sample. Results showed that D4 was a good drying method to preserve nutritional quality with good appearance. Among the pretreatments, C5 and C4 resulted improved nutritional quality retention, enhanced visual acceptability and enriched antioxidant activities. PCA (Principal Component Analysis) and correlation matrix revealed that D4 with C5 retained the maximum amount of vitamin, minerals, total phenolic content, antioxidant and admirable dehydrated carrot color by inactivating enzymatic reaction. Therefore, box solar drying with potassium metabisulfite pretreatment would be very promising for functional carrot drying retaining acceptable color and nutrition composition.

Pointed gourd (Trichosanthes dioica Roxb.) (2n = 2x = 22) is a dioecious cucurbit vegetable and green fruit that is edible after cooking. Consumers prefer to consume seedless or less-seeded fruit because seeds are unpalatable due to their hard coats. Therefore, the cross compatibility between the diploid and induced tetraploid will be helpful for seedless or less-seeded fruit production. Thus, the present study was conducted using mature seeds that were immersed in 0.05%, 0.1%, and 0.5% colchicine for 24, 48, and 72 h to induce tetraploids. These tetraploids were used as parents (male or female) in the inter-ploidy and intra-ploidy crosses. A flow cytometric analysis confirmed the induction of three tetraploids at 0.5% colchicine for 48 and 72 h soaking periods. Among these, two (2) females and one (1) male were differentiated after flower initiation. Crossing between the tetraploid’s maternal and diploid paternal parent (4x × 2x), which were revealed to be compatible, resulted in a similar fruit set rate and shape as those of the diploid. In addition, a seed number of 4x × 2x produced fruits that were drastically reduced to 1.8 seeds per fruit, whereas the natural diploid fruits had 26.4 seeds per fruit. These findings suggest that colchicine-induced tetraploid females are important genetic resources for less-seeded fruit production. The genetic stability of tetraploid clones can easily and effectively be maintained by vine cutting for advanced uses.

Rose (Rosa sp.) is one of the most important ornamentals which is commercialize for its aesthetic values, essential oils, cosmetic, perfume, pharmaceuticals and food industries in the world. It has wide range of variations that is mostly distinguished by petal color differences which is interlinked with the phytochemicals, secondary metabolites and antinutrient properties. Here, we explored the color, bioactive compounds and antinutritional profiling and their association to sort out the most promising rose genotypes. For this purpose, we employed both quantitative and qualitative evaluation by colorimetric, spectrophotometric and visual analyses following standard protocols. The experiment was laid out in randomized complete block design (RCBD) with three replications where ten rose genotypes labelled R1, R2, R3, R4, R5, R6, R7, R8, R9 and R10 were used as plant materials. Results revealed in quantitative assessment, the maximum value of lightness, and the luminosity indicating a brightening of rose petals close to a yellow color from rose accessions R4, and R10, respectively which is further confirmed with the visually observed color of the respective rose petals. Proximate composition analyses showed that the highest amount of carotenoid and β-carotene was found in R10 rose genotype, anthocyanin and betacyanin in R7. Among the bioactive compounds, maximum tocopherol, phenolic and flavonoid content was recorded in R8, R6 and R3 while R1 showed the highest free radical scavenging potentiality with the lowest IC₅₀ (82.60 µg/mL FW) compared to the others. Meanwhile, the enormous variation was observed among the studied rose genotypes regarding the antinutrient contents of tannin, alkaloid, saponin and phytate whereas some other antinutrient like steroids, coumarines, quinones, anthraquinone and phlobatanin were also figured out with their presence or absence following qualitative visualization strategies. Furthermore, according to the Principal Component Analysis (PCA), correlation matrix and cluster analysis, the ten rose genotypes were grouped into three clusters where, cluster-I composed of R3, R4, R5, R8, cluster-II: R9, R10 and cluster-III: R1, R2, R6, R7 where the rose genotypes under cluster III and cluster II were mostly contributed in the total variations by the studied variables. Therefore, the rose genotypes R9, R10 and R1, R2, R6, R7 might be potential valuable resources of bioactive compounds for utilization in cosmetics, food coloration, and drugs synthesis which have considerable health impact.

The rising demand for health promoting functional foods has sparked interest in diversifying diets by incorporating innovative items like edible flowers. Considering this, the nutritional composition, bioactive properties and antinutritional factors of the flowers of eight marigold genotypes (M₁ to M₈) were quantified and compared to elucidate their value and safety as functional food. The study outcomes highlighted significant differences among the genotypes for most of the attributes. Anthocyanin, carotenoid and lutein contents were observed within a range of 0.02 to1.90 mg/100 g, 5.02 to 11.08 mg/100 g and 0.19 to 9.78 µg/g, respectively. The content of sugars, β-carotene, vitamins (C and E) and minerals (sodium, potassium, calcium, magnesium and iron) were also found to be present in substantial amounts. The analysis of bioactive compounds revealed the richness in total phenolic (TPC) (428.58 to 592.71 mg gallic acid equivalent (GAE)/100 g) and flavonoid content (TFC) (135.06 to 233.39 mg quercetin equivalent (QE)/100 g). Among the assessed antinutrients, alkaloid, tannin and saponin exceeded permissible limits in the studied genotypes, while phytate remained within the safe range. However, the elevated levels of these antinutrients would not pose any problem if processed through methods such as soaking, boiling or cooking. Out of eight genotypes, M₁ had the highest content of anthocyanin (1.90 mg /100 g), reducing sugar (21.63 mg/100 g), and antioxidant activities. M₅ stood out with the highest levels of TSS (6.10 °Brix), β-carotene (0.50 mg/100 g), vitamin C (28.61 mg/100 g), Ca (225.33 mg/100 g), and TPC (592.71 mg GAE/100 g), while M₆ contained significant amounts of carotenoids (11.08 mg/100 g) and TFC (232.41 mg QE/100 g). Principal component analysis and cluster dendrogram findings further confirmed that among the eight studied genotypes, M₁, M₅ and M₆ genotypes were found as the most prominent with the remarkable contributions of the majority of the studied variables. Hence, these marigold genotypes could be considered as promising options to improve and diversify healthy diets, potentially serving as valuable sources of dietary supplements and functional food ingredients.