A regional, turbofan-powered, 72-passenger, transport aircraft with very high aspect ratio truss-braced wings is developed with an affordable methodology from an existing 52 passenger, conventional twin-turboprop aircraft. At first, the ration behind the selection of the truss-braced wing configuration is discussed. Next, the methodologies for the sizing, weight, aerodynamics, performance, and cost analysis are presented and validated against existing regional aircraft. The variant configurations and their design features are then discussed. Finally, sensitivity analysis is carried out to investigate the effects of the wing aspect ratio and engine bypass ratio on the aircraft weight, aerodynamics, and cost. It has been found that the penalties associated with the wing weight will prevent the acceptable realization of the high aspect ratio wing benefits, but when it is combined with the very high bypass ratio engines, a 17% reduction in the mission fuel weight is achieved. In contrast, the cost analysis has revealed that the application of higher aspect ratio wings in the truss-braced wing configuration may increase the development and maintenance costs. Consequently, with aspect ratios higher than 24, eventually, these costs may outperform the associated fuel cost reductions.
In this research, the architecture and the functionalities of the LAMBDA (Laboratory of Aircraft Multidisciplinary Knowledge-Based Design and Analysis) framework for the design, analysis, and optimization of civil aircraft are presented. The framework is developed in MATLAB R2022a and comprises a modular architecture, which gives the potential for the use of different methods and fidelities for each discipline. The methods can be selected from a set of built-in methods or custom user-defined scripts. Disciplinary modules of the LAMBDA are Requirements, Weight, Sizing, Geometry, Aerodynamics, Engine, Performance, Cost, Emission, and Optimization. This framework has been used for different types of design and optimization problems. When it is applied for the design and optimization of a novel regional TBW (Truss-Braced Wing) aircraft, the operating cost has been reduced by 7.7% in the optimum configuration compared to the base configuration.
A series of regional, turbofan-powered, 72 passenger, transport aircraft with very high aspect ratio truss-braced wings are developed with an affordable methodology from of an existing 52 passenger, twin turboprop aircraft; assuming entry into service in 2020s. At first, the ration behind the selection of the truss-braced wing configuration is discussed, and a methodology for the design and analysis of the configurations is presented and validated against an existing regional turboprop. The variant configurations and their design features is then discussed, and finally a sensitivity analysis were carried out to investigate the effect of the wing aspect ratio and engine bypass ratio on aircraft maximum take-off weight and design fuel weight. It was found that the combination of the very high aspect ratio truss-braced wing and very high bypass ratio engine would result in 17% reduction in the required mission fuel weight, relative to a conventional turbofan powered aircraft.
10 September 2024 in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
In this research, a method is developed to optimize the truss-braced wing aircraft configuration in a multidisciplinary design framework. Physics-based high-fidelity methods, that can capture the nature of the configuration changes, are employed for the disciplines where the existing classical methods are not reliable. High-fidelity geometry modeling, structure loading, structure optimization, and aeroelastic sizing methods are integrated into the aircraft multidisciplinary design and optimization. The developed algorithm is applied for the multi-objective optimization of a regional jet aircraft to minimize the cost and weight. The results demonstrate that the cost-optimum solution converges to a higher aspect ratio wing equipped with a higher bypass ratio engine, and a 7.94% reduction in the direct operating cost can be achieved. On the other hand, the weight-optimum wing planform tends to a slightly lower aspect ratio wing with a lower bypass ratio engine, while a 6.18% reduction in take-off weight is achieved. In addition to that, the findings of this study highlight the considerable effect that the engine technology has on the optimum layout, which suggests that the engine technology and its performance should also be a part of the design optimization process. The developed modular framework offers further optimization potential for the truss-braced wing aircraft, as more detailed models can be integrated.