Deeply subducted carbonates likely cause low-degree melting of the upper mantle and thus play an important role in the deep carbon cycle. However, direct seismic detection of carbonate-induced partial melts in the Earth’s interior is hindered by our poor knowledge on the elastic properties of carbonate melts. Here we report the first experimentally determined sound velocity and density data on dolomite melt up to 5.9 GPa and 2046 K by in-situ ultrasonic and sink-float techniques, respectively, as well as first-principles molecular dynamics simulations of dolomite melt up to 16 GPa and 3000 K. Using our new elasticity data, the calculated VP/VS ratio of the deep upper mantle (∼180–330 km) with a small amount of carbonate-rich melt provides a natural explanation for the elevated VP/VS ratio of the upper mantle from global seismic observations, supporting the pervasive presence of a low-degree carbonate-rich partial melt (∼0.05%) that is consistent with the volatile-induced or redox-regulated initial melting in the upper mantle as argued by petrologic studies. This carbonate-rich partial melt region implies a global average carbon (C) concentration of 80–140 ppm. by weight in the deep upper mantle source region, consistent with the mantle carbon content determined from geochemical studies. Significance Petrologic studies suggest that carbonate-rich melts are present in the Earth’s upper mantle and play an important role in the deep carbon cycle. However, seismic detection of these melts is difficult due to the lack of understanding of the elastic properties of carbonate melts. Here we determined the sound velocity and density of dolomite melt at upper mantle conditions using high-pressure experiments and theoretical simulations. The calculated velocities of carbonate melt-bearing mantle using these new elasticity data were compared with global seismic observations. The result suggests that ∼0.05% carbonate-rich melt can be pervasively present in the deep upper mantle, implying a global average mantle carbon concentration of 80-140 ppm.
Sound velocities of diopside liquid were determined at high pressures and temperatures up to 3.8 GPa and 2375 K, using the ultrasonic technique combined with synchrotron X‐ray diffraction and imaging in a multianvil apparatus. Our results show that the sound velocity increases with pressure but is nearly independent of temperature. Using a Monte Carlo approach, the measured high‐pressure sound velocities combined with ambient‐pressure density provide tight constraints for the equation of state of diopside liquid, with a best‐fit adiabatic bulk modulus (KS) of 23.8 ± 0.4 GPa and its pressure derivative (KS') of 7.5 ± 0.5. The calculated adiabatic temperature and density profile of diopside liquid suggest that a melt layer with diopside composition in the upper mantle would be gravitationally unstable and start to crystallize from the bottom of the layer during cooling. By comparing our results with previous acoustic measurements on silicate glasses, we demonstrate the important differences in sound velocities between silicate liquids and glasses and conclude that silicate glasses may not work as a good analog material for studying the acoustic properties of silicate liquids, as measurements on unrelaxed glasses do not capture the entropic contribution to the compressional properties of liquids. We modeled velocity reductions due to partial melts in the upper mantle using our results and found that for a given velocity reduction, the deeper the low‐velocity region, the larger the melt fraction is required. Using silicate glass data for such estimation would result in a significant underestimation of melt fractions at high pressures.
1 January 2022 in Earth and Planetary Science Letters
Fluids and melts in planetary interiors significantly influence geodynamic processes from volcanism to global‐scale differentiation. The roles of these geofluids depend on their viscosities (η). Constraining geofluid η at relevant pressures and temperatures relies on laboratory‐based measurements and is most widely done using Stokes' Law viscometry with falling spheres. Yet small sample chambers required by high‐pressure experiments introduce significant drag on the spheres. Several correction schemes are available for Stokes' Law but there is no consensus on the best scheme(s) for high‐pressure experiments. We completed high‐pressure experiments to test the effects of (a) the relative size of the sphere diameter to the chamber diameter and (b) the top and bottom of the chamber, that is, the ends, on the sphere velocities. We examined the influence of current correction schemes on the estimated viscosity using Monte Carlo simulations. We also compared previous viscometry work on various geofluids in different experimental setups/geometries. We find the common schemes for Stokes' Law produce statistically distinct values of η. When inertia of the sphere is negligible, the most appropriate scheme may be the Faxén correction for the chamber walls. Correction for drag due to the chamber ends depends on the precision in the sinking distance and may be ineffective with decreasing sphere size. Combining the wall and end corrections may overcorrect η. We also suggest the uncertainty in η is best captured by the correction rather than propagated errors from experimental parameters. We develop an overlying view of Stokes' Law viscometry at high pressures.
Compressional and shear wave velocities of polycrystalline stishovite (SiO2) have been measured at simultaneous high pressures and temperatures up to 14.5 GPa and 800°C. By fitting velocities to the finite strain equations, the elastic moduli and density were determined to be KS0 = 306.6(46) GPa, KS′ = 4.92(10), ∂KS/∂T = −0.024(1) GPa/K, G0 = 229.0(34) GPa, G′ = 1.07(10), ∂G/∂T = −0.017(1) GPa/K, ρ0 = 4.287(2) g/cm3. Our modeling suggested that, in the eclogite, coesite‐stishovite transition can increase P and S wave velocities by 2.4% and 3.5%, respectively. A comparison between geophysical observations and our model shows that the coesite‐stishovite phase transition in the eclogite can potentially be responsible for the occurrence of the X discontinuity beneath Hawaii. In addition, our current results suggest an eclogite‐rich layer between 340 and 450 km depth beneath Hawaii. The eclogite concentration at the top and bottom of the layer is 41–55 vol% and >77 vol%, respectively.