In this work, the effects of different process parameters on the material removal rate (MRR) of phosphate laser glass during ring polishing had been investigated. Experiments were performed on a ring polishing machine that had a pad diameter of 4.4 m, and the MRR was obtained by the measurements of depth reduction of a groove on phosphate glass sample. The experimental results and analyses showed that size of the abrasive particles and the ceria concentration had significant effects on the polishing rate. The MRR of glass being polished on the annular-grooved pad was almost three times as when polished on the square-grooved pad. When the pad was periodically cleaned with water and glass was polished with fresh slurry, the value of MRR tended to be constant. Based on the experimental results, a combined process was designed to optimize MRR. The results of this study provided the essential foundation for obtaining the required MRR and optimizing the fabrication technique.
Nanosecond single- and multiple-pulse laser damage studies on HfO2/SiO2 high-reflection (HR) coatings are performed at 532 nm. For single-pulse irradiation, the damage is attributed to the defects and the electric intensity distribution in the multilayer thin films. When the defect density in the irradiated area is high, delamination is observed. Other than the 1064 nm laser damage, the plasma scalding of the 532 nm laser damage is not pits-centered for normal incidence, and the size of the plasma scalding has no relation to the defect density and position, but increases with the laser fluence. For multiple-pulse irradiations, some damage sites show deeper precursors than those from the single-shot irradiation due to the accumulation effects. The cumulative laserinduced damages behave as pits without the presence of plasma scalding, which is unaffected by the laser fluence and shot numbers. The damage morphologies and depth information both confirm the fatigue effect of a HfO2/SiO2 HR coating under 532 nm laser irradiation.
Low dispersion mirrors are important because of their potential use in petawatt (PW) laser systems. The following two methods are known to increase the laser-induced damage threshold of low dispersion optical components: use of a wide-bandgap-material protective layer and control of electric field distribution. By controlling the electric field distribution of composite low-dispersion mirrors (CLDM), we shift the electric field peaks from the material interface into the wide-bandgap material. However, the damage threshold of modified-electric-field composite low dispersion mirror (E-CLDM) does not increase. Damage morphology shows that the initial damaged layer is Ta2O5. An immediate cause is the enhancement of the electric field in internal layers caused by surface electric field regulation. Theoretical calculations show that the damage threshold of CLDM or E-CLDM is determined by the competition results of bandgap and the electric field of layer materials. The CLDM with different materials or different protective layer periods can be optimally designed according to the electric field competition effect in the future.