High-precision and -resolution atmospheric boundary layer height (BLH) has received increasing attention in air pollution research in recent years. The low time resolution of sounding data is the main challenge to validate BLH retrieval from lidar observations. To resolve this issue, we conducted simultaneous tethered balloon sounding and lidar observations at the Semi-Arid Climate and Environment Observatory of Lanzhou University (SACOL) during winter 2019–2020. The BLHs derived from the tethered balloon sounding data were 170, 210, 393, 676, 423, and 190 m at 02:00, 08:00, 11:00, 14:00, 17:00, and 20:00 (Beijing time), respectively. The diurnal evolution of BLH was reasonably captured by lidar observation-based wavelet covariance transform and ideal profile fitting methods, which exhibited correlation coefficients of 0.91 and 0.89, respectively, with the BLHs determined from tethered balloon sounding data. The lidar results slightly overestimated the BLHs, though all results were acceptable when considering both the absolute and relative errors with respect to BLHs from the tethered balloon data. Our results revealed high-precision and -resolution diurnal variations in BLH at SACOL in Northwest China and suggest the importance of validating lidar-based BLHs using simultaneous sounding data.
21 February 2017 in Journal of Geophysical Research: Atmospheres
To assess the impacts of initial soil moisture (SMOIS) and the vegetation fraction (Fg) on the diurnal temperature range (DTR) in arid and semiarid regions in China, three simulations using the weather research and forecasting (WRF) model are conducted by modifying the SMOIS, surface emissivity and Fg. SMOIS affects the daily maximum temperature (Tmax) and daily minimum temperature (Tmin) by altering the distribution of available energy between sensible and latent heat fluxes during the day and by altering the surface emissivity at night. Reduced soil wetness can increase both the Tmax and Tmin, but the effect on the DTR is determined by the relative strength of the effects on Tmax and Tmin. Observational data from the Semi‐Arid Climate and Environment Observatory of Lanzhou University (SACOL) and the Shapotou Desert Research and Experimental Station (SPD) suggest that the magnitude of the SMOIS effect on the distribution of available energy during the day is larger than that on surface emissivity at night. In other words, SMOIS has a negative effect on the DTR. Changes in Fg modify the surface radiation and the energy budget. Due to the depth of the daytime convective boundary layer, the temperature in daytime is affected less than in nighttime by the radiation and energy budget. Increases in surface emissivity and decreases in soil heating resulting from increased Fg mainly decrease Tmin, thereby increasing the DTR. The effects of SMOIS and Fg on both Tmax and Tmin are the same, but the effects on DTR are the opposite.
To study the influence of complex terrain with different scales on the structure of near-surface turbulence, the turbulence observational data from Semi-Arid Climate and Environment Observatory of Lanzhou University (SACOL) were analyzed. SACOL is located in typical Loess Plateau topography. The terrain around the site varies greatly with the direction. Representative data from the Northeast, Southeast, Southwest, and Northwest were selected to study the structure characteristics of the near surface turbulence. The complex topography within the flux footprint enhances the vertical scale of turbulence σw and thereby increases the vertical–longitudinal ratio of turbulence Ar. While the turbulent horizontal scale σu is also significantly affected by the distant terrain beyond the flux footprint. The upwind terrain undulation increases σu and reduces Ar. Affected by the complex terrain, the ratio of the spectrum of the vertical velocity to that of the longitudinal velocity, Sw(n)/Su(n), is far less than 4/3 in the southwest direction, and the turbulence is significantly anisotropic.
The region surrounding the Tibetan Plateau (TP) is widely considered a primary global dust source, with mineral dust comprising a significant proportion of aerosols over the TP. Current research on TP dust has mainly focused on transport from the surrounding deserts, with little focus on dust emissions from the TP's interior. The erodibility factor used by the WRF‐Chem (ERODDEF) is 0 for the TP, so the model cannot simulate the dust emissions inside the plateau. Thus, we constructed a high‐resolution erodibility data set (ERODSDS) based on a reliable dust source distribution and intensity map. Based on the modified EROD map, the WRF‐Chem model was used to simulate dust emissions and direct radiative forcing on the TP in 2018. With the modified EROD map, WRF‐Chem can well simulate the temporal variation and spatial pattern of mineral dust on the plateau, which greatly improves the model's dust emissions simulation accuracy on the TP.