In this study, a portable and large-area blackbody system was developed following a series of processes including design, computational analysis, fabrication, and experimental analysis and evaluation. The blackbody system was designed to be lightweight (5 kg), and its temperature could exceed the ambient temperature by up to 15 °C under operation. A carbon-fiber-based heat source was used to achieve a uniform temperature distribution. A heat shield fabricated from an insulation material was embedded at the opposite side of the heating element to minimize heat loss. A prototype of the blackbody system was fabricated based on the design and transient coupled electro-thermal simulation results. The operation performance of this system, such as the thermal response, signal transfer function, and noise equivalent temperature difference, was evaluated by employing an infrared imaging system. In addition, emissivity was measured during operation. The results of this study show that the developed portable and large-area blackbody system can be expected to serve as a reliable reference source for the calibration of aerial infrared images for the application of aerial infrared techniques to remote sensing.

Predicting flood wave propagation from reservoir failures is critical to practical flood hazard assessment and risk management. Flood waves are sensitive to topography, channel geometry, structures, and natural features along floodplain paths. Thus, the accuracy of flood wave modelling depends on how precisely those features are represented. This study introduces an enhancing approach to flood wave modelling by accurately representing three-dimensional objects in floodplains using the structure-from-motion (SfM). This method uses an unmanned aerial vehicle to capture topographic complexities and account for ground objects that impact flood propagation. Using the three-dimensional volume of fluid numerical approach significantly improves an enhanced representation of turbulent flow dynamics and computational efficiency, especially in handling large topography datasets. Reproductions from this enhanced three-dimensional approach were validated against recent reservoir failure observations and contrasted with traditional two-dimensional models. The results revealed that the suggested three-dimensional methodology achieved a significant 84.4% reproducibility when juxtaposed with actual inundation traces. It was 35.5%p more accurate than the two-dimensional diffusion wave equation (DWE) and 17.1%p more than the shallow water equation (SWE) methods in predicting flood waves. This suggests that the reproducibility of the DWE and SWE decreases compared to the three-dimensional approach when considering more complex floodplains. These results demonstrate that three-dimensional flood wave analysis with the SfM methodology is optimal for effectively minimising topographic and flood wave reproduction errors across extensive areas. This dual reduction in errors significantly enhances the reliability of flood hazard assessments and improves risk management by providing more precise and realistic predictions of flood waves.

To analyze the effect of a groove cross-sectional shape on disc filters, a head loss analysis and filtration performance test were conducted using disc filters with different groove shapes (semi-elliptical- and trapezoidal-shaped grooves). Furthermore, the groove shapes were analyzed using field emission scanning electron microscopy and the relationship between flow rate and head loss was derived from the head loss test. Even if the filters were designed with the same mesh standard, the sectional areas of the grooves were different depending on the shape. Therefore, the head loss was compared under the condition that the grooves have the same sectional area by applying the relationship between head loss and sectional area, and a smaller head loss was observed in the semi-elliptical-shaped groove. Additionally, the semi-elliptical-groove-shaped disc filter was evaluated to sufficiently filter the soil particles corresponding to the 120 mesh standard. Therefore, an optimum disc filter can be designed by considering the cross-sectional shape of the disc groove to reduce energy consumption and provide stable filtration. The elliptical groove shape, which is hydraulically advantageous, is preferred for the disc filter design.