This paper describes a systematic and comprehensive hot-wire investigation into the turbulent statistics of low-, moderate- and high-speed subsonic jets. Experiments were performed to obtain the one-point and two-point statistics of a single-stream, unheated jet turbulence field over a broad region of the jet plume. Results show that hot-wires can be used to measure both the one-point and two-point statistics of the high turbulence intensity, noise-producing regions of unheated, compressible, subsonic jets. For the two-point measurements, probe pairings are performed over the three orthogonal axes. Analysis of the experimental data reveals four main conclusions: (1) both the statistical and joint moments of the turbulence scale well with the local jet shear layer half-width; (2) a simple relationship exists between the statistics of the velocity fluctuations and the square of the velocity fluctuations; (3) a simple relationship exists between the longitudinal and transverse length-scales, and (4) a semi-empirical model has been developed to predict the cross-correlation coefficients, power spectral density, frequency-dependent length-scales and coherence decay of the turbulent velocity field. From the second and third conclusions, it is shown that, in the locations near an eddy’s centre of rotation (i.e. the midpoint of the jet shear layer), the turbulence statistics can be described as quasi-homogeneous and quasi-frozen. The joint statistical moments, therefore, can be inferred simply from single-point tests. These results will help to develop models for predicting jet mixing noise, highlighting the situations in which the simplifying assumptions are inadequate.
Extra noise is generated when jets are installed beneath solid surface. In this paper, large-eddy simulation (LES) has been used to investigate these jet installation effects. The simulations were ...
A model-scale experimental investigation of an installed jet–pylon–wing configuration was conducted at the University of Southampton, with the scope to study the effect a pylon has on noise generation and to clarify its impact on the fluctuating wall-pressure load. The set-up consisted of two single-stream nozzles, a baseline axisymmetric annular nozzle and a partially blocked annular pylon nozzle. The nozzles were tested first isolated and then installed next to a NACA4415 aerofoil ‘wing’ at a single nozzle–wing position. The jet Mach number was varied between $0.5 \leq M_{{j}} \leq 0.8$ and measurements were performed both under static and in-flight ambient flow conditions up to ${M_{{f}} = 0.2}$ . The jet flow-field qualification was carried out using a single-velocity-component hot-wire anemometer probe. The pressure field on the wing surface was investigated using two miniature wall-pressure transducers that were flush-mounted in the streamwise and spanwise directions within the pressure side of the wing. A linear ‘flyover’ microphone array was used to record the noise radiated to the far field. The unsteady pressure data were analysed in both time and frequency domains using multi-variate statistics, highlighting a far-field noise reduction provided by the presence of the pylon only in the installed case. Furthermore, the wake field generated behind the pylon is seen to significantly modify the wall-pressure fluctuations, particularly at streamwise locations close to the pylon trailing edge.
In this paper, insight is provided into the modeling of single-point and two-point statistics of a subsonic round jet discharged into a moving ambient medium. An experimental campaign has been perf...
This work presents a detailed study of the turbulence flow statistics of a jet mounted with its axis parallel to a rigid flat plate. Hot-wire constant temperature anemometry has been used to measure the single-point and two-point statistics of the axial velocity component at several locations within the jet flow field. Results show that the jet mean flow near the plate surface is subjected to a local acceleration and redirection due to a Coandă-type effect. The propagation of these effects downstream of the plate trailing edge is strongly dependent on the plate position. Regarding the velocity fluctuations, the mean turbulence intensity levels are seen to decrease as the radial distance between the jet and surface decreases. Analysis of the single-point power spectral density data on the shear layer close to the plate shows that the reduction in magnitude of the low-frequency content of the energy spectrum is responsible for the decrease in turbulence intensity. Additionally, the characteristic time and length scales computed from two-point measurements reduce as the plate is mounted closer to the jet centre-line. The axial eddy convection velocity is seen to increase in the region of high turbulent kinetic energy in the shear layer adjacent to the surface. Empirical models for turbulence characteristic scales and eddy convection velocity are presented. These findings suggest that both the amplitude and distribution of the jet mixing noise sources are affected when closely installed next to a surface. This paper is a continuation of a recent investigation on the turbulence statistics of isolated jets presented in Proença (Exp Fluids 60(4):63, 2019).Graphic
15 June 2020 in International Journal of Aeroacoustics
This work provides an experimental investigation into the interaction between a jet flow and a semi-finite plate parallel to the jet. Wall pressure fluctuations have been measured in a high compressible subsonic regime and for different distances between the jet and the plate trailing edge. The experiment has been carried out in the ISVR anechoic Doak Laboratory at the University of Southampton, using wall pressure transducers flush mounted on the plate surface. Signals were acquired in the stream-wise direction along the jet centreline and in the span-wise direction in a region close to the trailing edge. The radial position of the flat plate was fixed very close to the jet axis to simulate a realistic jet–wing configuration. The plate was moved axially in order to investigate four different jet-trailing edge distances and to include measurements upstream of the nozzle exhaust. The acquired database was analyzed in both the frequency and the time domains providing an extensive statistical characterization in terms of spectral uni– and multi–variate quantities as well as high order statistical moments. A wavelet analysis was performed as well to investigate the time evolution of the wall pressure events.