Conductive submicronic coatings of carbon black (CB)/silica composites have been prepared by a sol-gel process and deposited by spray-coating on glazed porcelain tiles. Stable CB dispersions with surfactant were rheologically characterized to determine the optimum CB-surfactant ratio. The composites were analyzed by Differential Thermal and Thermogravimetric Analysis and Hg-Porosimetry. Thin coatings were thermally treated in the temperature range of 300-500degC in air atmosphere. The microstructure of the coatings was determined by scanning electron microscopy and the structure evaluated by confocal Raman spectroscopy. The electrical characterization of the samples was carried out using dc intensity-voltage curves. The coatings exhibit good adhesion, high density and homogeneous distribution of the conductive filler (CB) in the insulate matrix (silica) that protects against the thermal degradation of the CB nanoparticles during the sintering process. As consequence, the composite coatings show the lowest resistivity values for CB-based films reported in the literature, with values of ~7times10 -5Omegam
1 July 2018 in Journal of the European Ceramic Society
Decreasing the particle size, improving the distribution of the particle size, avoiding a high agglomeration state and maintaining the photoluminescence response of SrAl2O4 doped with Eu2+ and Dy3+ powders is still a challenge in the processing of this phosphorescent material. Here, we explore different processes to achieve this objective. The standard route is a wet milling process, however the presence of a liquid medium promotes the hydrolysis of the material, and therefore its results are deleterious for its functional properties. These problems may be avoided if the milling is carried out by means of a dry process. For this reason, the powders are milled following two different procedures: high and low energetic dry milling processes. A correlation between the reduction of particle size and intensity of the photoluminescent emission has been evaluated. In this context, this study develops different processing routes to reduce the particle size on phosphor powders, seeking an agreement between the optical properties and the size of the powders, that depend on the final requirements.