Carbon dots (CDs) having low cost and low toxicity and synthesized via a green route were applied to establish a fluorescent nanoprobe for the measurement of glyphosate. The synthesis was realized via a one-pot hydrothermal procedure using Sophora japonica leaves as the carbon source. It was found that electron transfer occurred between Fe3+ and the as-prepared CDs. Therefore, Fe3+ exhibited a specific dynamic-quenching toward CDs. However, the electron transfer process was inhibited by glyphosate. The fluorescence of the quenched CDs/Fe3+ system was recovered by the addition of glyphosate. It resulted from the strong complexation between Fe3+ and the functional groups (like –PO3H2 and –COOH) in the glyphosate molecule. These functional groups captured Fe3+ from the CD/Fe3+ system to reduce the electron transfer. With such a design, the rapid detection of glyphosate could be realized by this turn-on fluorescent sensor based on the CD/Fe3+ system. Under optimal conditions, the CD/Fe3+ system showed a concentration-dependent fluorescent response toward glyphosate in the linear range from 0.1 to 16 ppm. The limit of detection was calculated to be as low as 8.75 ppb (3σ/S). In addition, the successful detection of glyphosate in real samples with satisfactory recoveries exhibited a practical application of the CD/Fe3+ nanoprobe in food safety and environmental monitoring.
A dual-cloud point extraction (d-CPE) technique combined with inductively coupled plasma mass spectrometry (ICP-MS) was used for preconcentration and determination of Cr, Ga, Ag, Cd, Mn, Fe, In, Cu, Ni, Co, Pb and Zn in real water samples. An orthogonal array design (OAD) with the OA25 (56) matrix was employed to study the effects of different parameters on the extraction efficiency. Under the best experimental conditions (concentration of complexing reagent 8-hydroxyquinoline, 0.25 mmol L−1; pH, 6.5; equilibrium temperature, 60 °C; surfactant Triton X-114, 0.1%; equilibrium time, 30 min and without salt addition), the enhancement factor ranged from 9.85 to 35.98. The linear dynamic range (LDR) was 1–800 μg L−1 with correlation coefficients of 0.9974–0.9999 and the limits of detection (LODs) were between 0.012 and 0.36 μg L−1. Relative standard deviations (RSDs, C = 10 μg L−1 and n = 6) were 1.29%–5.56%. Finally, the developed method was successfully applied to extraction and determination of the mentioned metal ions in real water samples and satisfactory results were obtained.