Maria Klepikova

Dr. Maria Klepikova

Institute of Earth Sciences, University of Lausanne, 1015 Lausanne, Switzerland

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 February 2018 in Solid Earth
Verified
Journal Article
Open access
PDF file
FAFlorian Amann
Florian Amann
VGValentin Gischig
Valentin Gischig
KEKeith Evans
Keith Evans
JDJoseph Doetsch
Joseph Doetsch
RJReza Jalali
Reza Jalali
DGDomenico Giardini
Domenico Giardini
In this contribution, we present a review of scientific research results that address seismo-hydromechanically coupled processes relevant for the development of a sustainable heat exchanger in low-permeability crystalline rock and introduce the design of the In situ Stimulation and Circulation (ISC) experiment at the Grimsel Test Site dedicated to studying such processes under controlled conditions. The review shows that research on reservoir stimulation for deep geothermal energy exploitation has been largely based on laboratory observations, large-scale projects and numerical models. Observations of full-scale reservoir stimulations have yielded important results. However, the limited access to the reservoir and limitations in the control on the experimental conditions during deep reservoir stimulations is insufficient to resolve the details of the hydromechanical processes that would enhance process understanding in a way that aids future stimulation design. Small-scale laboratory experiments provide fundamental insights into various processes relevant for enhanced geothermal energy, but suffer from (1) difficulties and uncertainties in upscaling the results to the field scale and (2) relatively homogeneous material and stress conditions that lead to an oversimplistic fracture flow and/or hydraulic fracture propagation behavior that is not representative of a heterogeneous reservoir. Thus, there is a need for intermediate-scale hydraulic stimulation experiments with high experimental control that bridge the various scales and for which access to the target rock mass with a comprehensive monitoring system is possible. The ISC experiment is designed to address open research questions in a naturally fractured and faulted crystalline rock mass at the Grimsel Test Site (Switzerland). Two hydraulic injection phases were executed to enhance the permeability of the rock mass. During the injection phases the rock mass deformation across fractures and within intact rock, the pore pressure distribution and propagation, and the microseismic response were monitored at a high spatial and temporal resolution.

8 March 2018 in Geophysical Research Letters
Verified
Journal Article
Closed access
PDF file
MJMohammadreza Jalali
Mohammadreza Jalali
VGValentin Gischig
Valentin Gischig
JDJoseph Doetsch
Joseph Doetsch
RNRico Näf
Rico Näf
HKHannes Krietsch
Hannes Krietsch
DGDomenico Giardini
Domenico Giardini

18 April 2020 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
PDF file
BBB. Brixel
B. Brixel
MKMaria Klepikova
Maria Klepikova
MJMohammadreza Jalali
Mohammadreza Jalali
QLQ. Lei
Q. Lei
CRC. Roques
C. Roques
SLSimon Loew
Simon Loew
New in situ measurements to constrain the range, distribution, and spatial (meter‐scale) variations of permeability in shallow crustal fault zones are reported based on systematic downhole tests at 0.5‐km depth in crystalline rock. Single and cross‐hole hydraulic packer tests were performed at a new dedicated test facility hosted in the Grimsel Test Site, in the Swiss Alps, following the technical instrumentation and isolation of discrete fault zones accessed by an array of boreholes. Single‐hole test results are presented in this paper, while cross‐hole experiments are reported in the companion paper. Our results reveal a sharp spatial falloff in permeability, from 10‐13 to 10‐21 m2, with off‐fault distances of 1–5 m and characterized by a power‐law relation with fracture density. Fractures linking subparallel faults were detected as high‐permeability discrete spots several meters away from off‐fault damage. Due to the narrow (centimeter‐wide) thickness of fault cores, the hydraulic tests presented in this study do not characterize the permeability of fault core materials. The transmissivity of single fractures spans six orders of magnitude (10‐12 to 10‐6 m2/s) and is systematically higher in damage zones. In situ stresses appear to have a minor effect on natural, present‐day fracture transmissivity at the borehole scale. We suggest that the geometrical and topological properties of fracture systems instead tend to control the permeability of the shallow crustal faults studied.

22 February 2018 in Water Resources Research
Verified
Journal Article
Open access
PDF file
MKMaria Klepikova
Maria Klepikova
CRClement Roques
Clement Roques
SLSimon Loew
Simon Loew
JSJohn Selker
John Selker
The range of options for investigation of hydraulic behavior of aquifers from boreholes has been limited to rigid, cumbersome packers, and inflatable sleeves. Here we show how a new temporary borehole sealing technique using soft grains of polyacrylamide (PAM) gel as a sealing material can be used to investigate natural groundwater flow dynamics and discuss other possible applications of the technology. If no compressive stress is applied, the gel packing, with a permeability similar to open gravel, suppresses free convection, allowing for local temperature measurements and chemical sampling through free‐flowing gel packing. Active heating laboratory and field experiments combined with temperature measurements along fiber optic cables were conducted in water‐filled boreholes and boreholes filled with soft grains of polyacrylamide gel. The gel packing is shown to minimize the effect of free convection within the well column and enable detection of thin zones of relatively high or low velocity in a highly transmissive alluvial aquifer, thus providing a significant improvement compared to temperature measurements in open boreholes. Laboratory experiments demonstrate that under modest compressive stress to the gel media the permeability transitions from highly permeable to nearly impermeable grouting. Under this configuration the gel packing could potentially allow for monitoring local response pressure from the formation with all other locations in the borehole hydraulically isolated.

18 April 2020 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
PDF file
BBB. Brixel
B. Brixel
MKMaria Klepikova
Maria Klepikova
QLQ. Lei
Q. Lei
CRC. Roques
C. Roques
MJMohammadreza Jalali
Mohammadreza Jalali
SLSimon Loew
Simon Loew
Cross‐hole fluid injection tests were performed on shallow (0.5 km depth) crustal fault zones to characterize their internal flow structures on scales of 3–30 m. The data were acquired at the Grimsel Rock Laboratory, Switzerland, after the zonal isolation of damage zones in boreholes equipped with multipacker systems. We show that 80% of the pressure responses detected evolved as a power function of time due to fracture‐controlled flow and were best described by a fractional model with a flow dimension (n) in the range of [1.3,1.5]. The scaling of characteristic times (tc) and intermediate transitions in the flow dimension is shown to be inconsistent with the trend expected for normal diffusion, indicating a diffusion slowdown process caused by the spatial integration of structurally different damage zones. An analysis of the entire data set points to a subdiffusive regime where the mean squared displacement of pressure fronts, ⟨r2(t)⟩, scales as ⟨r2(t)⟩∝t0.59, similar to an anomalous diffusion process on synthetic fractal systems. We characterize this diffusion slowdown by calculating a network connectivity exponent (θ) of 1.4, from which we estimate a fractal dimension of df=2.23 for the tested fault zones. Such a value close to 2.0 supports the view of fault damage zones as hierarchical systems promoting flow channeling. Our results provide further support to theoretical models of fractional flow and their application to fractured media in nature.

5 July 2024 in Water Resources Research
Verified
Journal Article
Open access
WSWenguang Shi
Wenguang Shi
QWQuanrong Wang
Quanrong Wang
MKMaria Klepikova
Maria Klepikova
Hongbin ZhanHongbin Zhan
Hongbin Zhan
A fundamental assumption in numerous studies of heat transfer in porous media is local thermal equilibrium (LTE), which assumes that the temperature of the porous media at the fluid and solid interface is in instantaneous equilibrium. Although significant efforts have been made to quantify the occurrence and consequences of local thermal nonequilibrium (LTNE), where the temperatures of the fluid and adjacent solid phases differ, there is no simple expression for quantifying the occurrence and effects of local thermal disequilibrium. Using a numerical model combining LTE and LTNE models, we develop here two simple general criteria based on Darcian velocities (q) and particle sizes (dp) of porous media for determining when LTNE effects occur (denoted as g(dp, q)) and when they become significant (denoted as f(dp, q)). Results show that using an LTE model can result in an underestimation of effective thermal diffusivity and the unaffected Darcian velocities when g(dp, q) > 0. It is possible that using the LTE model can result in an underestimation of the effective thermal diffusivity by more than 200 times within Darcian velocities ranging from 0 to 60 m/d. In the case of g(dp, q) < 0, the use of the LTE model can result in an overestimation of effective thermal diffusivity and Darcian velocities. The performances of the newly developed general criteria are demonstrated using three typical data sets and corresponding numerical models. These data sets include new heat tracer tests conducted in the laboratory and the field, as well as temperature‐time series collected in streambed sediments from a previous study by Shanafield et al. (2012, https://doi.org/10.5194/hessd‐9‐4305‐2012). The potential LTNE effects should be considered when using heat as a tracer to characterize flow and heat transport in porous media in the presence of Darcian velocities less than 2 m/d and particle sizes larger than 10 mm.