Tectonic development of the Andean Cordillera has profoundly changed the topography, climate, and vegetation patterns of the southern central Andes. The Cenozoic Bermejo Basin in Argentina (~30°S) provides a key record of thrust belt kinematics and paleoclimate south of the high-elevation Puna Plateau. Ongoing debate regarding the timing of initiation of upper plate shortening and Andean uplift persists, precluding a thorough understanding of the earlier tectonic and climatic controls on basin evolution. We present new sedimentology, detrital geochronology, sandstone petrography, and subsidence analysis from the Bermejo Basin that reveal siliciclastic-evaporative fluvial and lacustrine environments prior to the main documented phase of Oligocene-Miocene shortening of the Frontal Cordillera and Argentine Precordillera. We report the first radiometric dates from detrital zircons collected in the Ciénaga del Río Huaco Formation, previously mapped as Permian, that constrain a Late Cretaceous (~95–93 Ma) maximum depositional age. Provenance and paleocurrent data from these strata indicate that detritus was derived from dissected arc and cratonic sources in the north and northeast. Detrital zircon U-Pb ages of ~37 Ma from the overlying red beds suggest that foredeep sedimentation began by at least the late Eocene. At this time, sediment dispersal shifted from axial southward to transversal eastward from the Andean Arc and Frontal Cordillera. Subsidence analysis of the basin fill is compatible with increasing tectonic deformation beginning in Eocene time, suggesting that a distal foredeep maintained fluvial connectivity to the hinterland during topographic uplift and unroofing of the Frontal Cordillera, prior to Oligocene-Miocene deformation across the Precordillera.
1 December 2021 in Journal of South American Earth Sciences
Several major (up to MW7.5) earthquakes over the past 320 years have shaken the thick‐skinned Sierras Pampeanas region of Argentina, despite exhibiting much lower GPS‐shortening rates than across the thin‐skinned Precordillera region to its west. Whether geodetic shortening rates indicate an actual long‐term shortening gradient, and whether shortening rates translate to higher uplift rates due to steeper faults in the Sierras Pampeanas, remain uncertain due to the limited spatio‐temporal coverage and the inherently large error in the vertical component of deformation of GPS measurements. We measure geomorphic offsets and use10Be terrestrial cosmogenic nuclide surface exposure dating to determine slip rates on the Las Chacras Fault Zone (LCFZ)—an ∼30 km long, NNW‐trending, steeply dipping (55–65°E) reverse fault that branches off of the longest, westernmost, thick‐skinned Valle Fértil range‐front fault in the western Sierras Pampeanas. Average shortening and uplift rates measured on the LCFZ are ∼0.2 and ∼0.3–0.4 mm/yr, respectively. Despite an uplift rate similar to most other faults in the region, the LCFZ shortening rate is lower than faults to its west; this is in agreement with the inferred west‐east decrease in shortening rates from GPS data, indicating consistent regional deformation patterns since the Late Pleistocene. The decrease in shortening to the east coincides spatially with the termination of the flat portion of the subducted Nazca plate between 67 and 68°W. From scaling relationships among magnitude, slip rate, and fault length, the LCFZ is capable of generating earthquakes of MW6.7–7.1.
23 April 2022 in Journal of South American Earth Sciences
The Iglesia basin, in the San Juan Province, is the northern part of a Cenozoic piggy-back basin (the Iglesia-Calingasta-Uspallata basin), located above of the active flat-slab subduction zone of western Argentina. This basin is located between two mountain ranges, the Cordillera Frontal to the west and the Precordillera to the east, affected by thin and thick skinned tectonics, respectively. It is elongated in a north-south direction (70 km) and has a maximum width of 35 km. We have analyzed 17 seismic reflection lines corresponding to more than 500 km of interpreted sections. A strong reflection at 0.5-2 s is interpreted as indicative of shales and sandstones in the upper part of the Agua Negra Formation (Carboniferous); this represents a seismic basement for the Iglesia basin clearly separating stratified (shallower) from chaotic (deeper) reflectors. Several high angle faults have been recognized in the interpreted seismic lines affecting the Neogene fill and even the basement; some of them correlate with structures observed at the surface such us El Tigre Fault System. A 3D model shows the seismic top of basement smoothly deepening down to 3,650 m beneath the Pismanta area. The basement continues upward to the east with a steeper slope clearly defining an asymmetrical shape for the basin. Moreover, there are three depocenters of similar maximum depths around the geothermal hot spring of the Pismanta center. Some of the interpreted faults may be helping in the outflow process of meteoric water heated by a normal geothermal gradient. Considering earthquake data framework, our observations correlate with transpressive deformation likely associated with El Tigre Fault System, which affects Neogene and Pleistocene strata of the Iglesia Group.
25 July 2026 in Journal of Geophysical Research: Solid Earth
The Central Andean Cordillera between 22°–24°S contains among the highest elevations and largest ignimbrite eruptions on Earth. Cenozoic crustal shortening is a major contributor to orogenic thickening and, while deformation in the upper crust is reasonably well constrained, deeper crust and lithospheric structures remain less understood. From 2022 to 2024, we deployed 298 nodal and 36 broadband seismometers across the Andes in northern Chile and Argentina and calculated high‐frequency receiver functions (RFs) to identify discontinuities in the crust and mantle from the coast to the foreland. In the Andean forearc, we image the oceanic crust top and Moho discontinuities where amplitudes gradationally increase along dip, indicating a transition in the overlying lithology from serpentinized mantle, to hot and coupled mantle wedge. Beneath the Puna Plateau, we image a complex gradational/layered Moho with thinner crust (depth ∼58 km bsl ) beneath the arc compared to thicker crust (depth ∼64 km bsl ) under the eastern Puna plateau with changes in Moho depth likely related to lithospheric removal processes. In the upper crust, we observe the well‐known Altiplano‐Puna Magma Body and additional widespread low velocity zones (<30 km bsl ) throughout the entire Puna, interpreted as additional regions of mid to upper crustal partial melt zones. Beneath the Eastern Cordillera and Santa Barbara thrust belt are a set of west‐dipping discontinuities consistent with the Main Andean Detachment system. These discontinuities merge into the low velocity zones in the Puna at a depth of ∼18–20 km possibly indicating a systemic connection between shortening structures and plateau magmatism.