The accumulation of phosphogypsum waste from the fertilizer industries, which remain in regulated stacks occupying considerable land resources, is causing significant environment problems worldwide. In that sense, the scientific community is being pressured to find alternative ways for their disposal. In this research, we propose a novel application for phosphogypsum waste, as a modifier of bitumen for flexible road pavements. Viscous flow tests carried out on bitumen modified with a phosphogypsum waste and doped with sulfuric acid demonstrated an extraordinary increase in viscosity, at 60°C, when compared to a counterpart sample which had been modified with gypsum, the main component of phosphogypsum. Similarly, a significant improvement in the viscoelastic response of the resulting material at high temperatures was also found. FTIR (Fourier transform infrared spectroscopy) scans provided evidences of the existence of chemical reactions involving phosphorus, as revealed by a new absorption band from 1060 to 1180cm(-1), related to COP vibrations. This result points at phosphorus contained in the phosphogypsum impurities to be the actual "modifying" substance. Furthermore, no COP band was observed in the absence of sulfuric acid, which seems to be the "promoting" agent of this type of bond.
Castor oil (CO) functionalized by isocyanate groups (–NCO) is proposed as a novel bio-based reactive polyurethane (PU) for bitumen modification. This work presents a comparative analysis conducted on blends of bitumen and 2 wt.% of a PU prepolymer prepared by NCO-functionalization of castor oil. Four preparation procedures were evaluated, which resulted from the combination of two processing times (1h or 24h, at 90ºC) followed by two different post-treatments (water addition or ambient curing for up to 6 months). It was found that the degree of modification attained after post-treatment depends on the previous processing conditions. Thus, short processing times are required if the binder is further subjected to ambient curing. Instead, the success of the water-addition modification falls on a previous long processing step. As revealed by rheological tests, ambient curing was seen to be by far a more efficient way of modification if compared to direct addition of water, and makes clear that the resulting binder evolves towards a better performance when in service. In that sense, Thin Layer Chromatography tests, Modulated DSC and AFM images demonstrated a more complex microstructure characterized by the presence of a larger content of molecules with higher polarity, size and molecular weight.This work is part of two research projects sponsored by a MEC-FEDER Programme (Research Project MAT2007-61460) and by a Junta de Andalucia Programme - 19 - (TEP6689). The authors gratefully acknowledge their financial support. A.A. Cuadri also thanks “Ministerio de Educación” for the concession of a F.P.U. research grant (AP2008-01419)