This study evaluates the influence of polymer-modification on the induction heating capability of asphalt mastic in a microwave field, and investigates how effectively this approach can be utilized for ice melting and self-healing purposes. To this end, different asphalt mastic mixtures with different polymer-modification and mixing procedures were tested under microwave field exposure for induction heating capability, ice-melting ability, and self-healing capacity. The mixtures were made through warm-mix and hot-mix procedures with four bituminous binders, including virgin (unmodified) asphalt and the same binder modified with three types of polymers. The results showed the effectiveness of microwave induction heating of asphalt mastic for both crack-healing and deicing purposes. The binder type was found to influence the ice melting and crack healing rates, such that using a warm-mix asphalt binder resulted in a more efficient heat generation and conduction than using a virgin asphalt binder. While polymer-modification undermined induction-heating, ice-melting, and self-healing performances, SBS-modified asphalt binders exhibited better performance than the other polymer-modified binders.
Utilizing the self-healing properties of asphalt materials is a way to improve the service life of asphalt pavements. Enhanced self-healing capabilities can be achieved through mixture modification. Using waste or by-product materials to modify asphalt mixtures can provide further environmental benefits. However, with a given mixture modification method, the resulting materials should be adequately vetted to ensure that enhanced self-healing capability is not attained at the expense of the mixture’s overall performance. This research aims to investigate the feasibility of using zinc slag filler to enhance the self-healing properties of warm mix asphalt (WMA) and evaluates the rutting susceptibility and moisture-resistance of the slag-modified mixtures. To this end, zinc slag filler was used to replace a portion of the mineral filler at different replacement rates in WMA mixtures. Self-healing capabilities of the resulting mixtures were studied under microwave induction heating. The influence of zinc slag modification on asphalt mixture’s characteristics and conventional performance indicators were evaluated by the Texas boiling test, the three-point bending test, and the Kim test (a deformation test). Also, the adhesion between bitumen and aggregate was evaluated using the broken sample from the three-point bending test and digital image analysis. The results of self-healing tests demonstrated that the heat generation capability of the specimens increased with filler replacement rate, such that the specimens with 100% of the mineral filler replaced with slag showed the highest heating performance. Zinc slag filler showed the potential to improve the moisture resistance of WMA by enhancing aggregate–bitumen adhesion and thus reducing stripping. The slag-modified WMA samples exhibited better tensile strength ratio (TSR) and deformation resistance than their non-modified equivalents.
12 December 2017 in KSCE Journal of Civil Engineering
Analysis of crash rates in the world reveals a number of factors including road geometry and human behavior which should be scrutinized. In fact, many studies have been conducted on how to decrease crash rates that are related to the relationship between human behavior and road geometry. In this research, 324 scenarios were evaluated to simulate vehicle dynamics with the use of Carsim and Trucksim simulation software. To be more specific, the impacts of shoulder width, slope of shoulder and material of shoulder surface on the enhancement of safety based on driver behavior and road geometry were studied, through the use of vehicle dynamic simulation. In the study, based on the position of vehicles in horizontal curves in various types of shoulders, models were achieved for the roll angle of vehicles. The research included: 1-3D modeling by using simulation software, 2- Evaluating roll angle changes in different types of vehicle locations on shoulders versus speed changes, and 3- Presenting multiple linear regression models to connect the variables by statistical programs. Results indicate that shoulder type (width, material and cross slope) influences the safety considering the roll angle of the vehicle. This influence depends on dynamic and geometric characteristics and type of the vehicle.
19 July 2022 in Iranian Journal of Science and Technology, Transactions of Civil Engineering