The optimization of civil engineering structures is critical for enhancing structural performance and material efficiency in engineering applications. Structural optimization approaches seek to determine the optimal design, b... | Find, read and cite all the research you need on Tech Science Press
Shape adjustment and stress control can be considered as one of the effective parameters in prestressed cable structures since such structures are widely constructed nowadays due to their characteristics. The assembly errors and applied loads hugely affect the cables’ nodal positions and stress due to their delicacy. The former could disturb the shape, which affects the appearance and the function of the structure. In contrast, the latter may increase the stress in some cables above the upper limit or induce slack in some others. Accordingly, a technique has been proposed that combined fmincon optimization that relies on four different algorithms with a controlling approach based on the force method. The presented method aims to minimize the total amount of actuation and miniaturize the number of actuators. The targets of previously confirmed techniques can be obtained with less actuation and fewer actuators by using the current technique. Based on the verified examples, the advantage of the current approach over the quoted methods is up to 55% and 37% in terms of the number of actuators and the total amount of actuation, respectively.
This paper describes a method to control the nodal displacement of prestressable truss structures within the desired domains. At the same time, the stress in all members is unleashed to take any value between the allowable tensile stress and critical buckling stress. The shape and stresses are controlled by actuating the most active members. The technique considers the members’ initial crookedness, residual stresses, and slenderness ratio (S). Furthermore, the method is premeditated so that the members with an S between 200 and 300 can carry only tension before and after adjustment (i.e., the maximum compressive stress for the members with an S between 200 and 300 is zero). In addition, the derived equations are coupled with an optimization function that relies on five optimization algorithms (interior-point, trust-region-reflective, Sequential quadratic programming (SQP), SQP-legacy, and active-set). The algorithms identify and then exclude inactive actuators in the subsequent iterations. The technique is applied to several examples, and its results are compared with a quoted method in the literature.
3 December 2022 in International Journal of Civil Engineering
Traditional shape and stress control of structures use many actuators and require enormous time to find reasonable solutions that need designers to input specific target displacement and stress. This study employs a linear technique to static shape and stress control of pin-jointed assemblies as a theoretical advancement to prior works and provides a comparative analysis against previously established works. The study evaluates the proposed method using MATLAB to find the optimum set of actuators, and MATLAB and SAP2000 to verify the actuation results obtained through applying the set of actuations to the numerical models. The proposed method minimizes the number of trials, count of actuators, and total actuation up to 83%, 73%, and 50%, respectively. Furthermore, the optimum solution could be found in a single trial. The study focuses on the three aspects: (a) finding the optimal count of actuators; (b) optimum amount of actuation using fmincon function; and c) Implementing two-sided inequalities to control equations allowing designers to develop target internal forces and nodal displacements, as domains rather than specific numbers. This improves the optimization process affecting actuator count, total actuation elements, and processing time.
1 June 2017 in International Journal of Computational Methods and Experimental Measurements