The Korba region in northwestern Tunisia has a coastal aquifer that is impacted by intensive irrigation, urban expansion, and sensitivity to SWI. We assessed the vulnerability extent of Korba’s GW to SWI. We utilized a parametric model for GW vulnerability assessment, the GALDIT, which considers six parameters to determine SWI effects. The GALDIT map has four rating categories (≥7.5, 7.5–5, 5–2.5, and <2.5), representing very high, high, moderate, and low vulnerability, respectively. Most of the region was found to be highly vulnerable (44.2% of the surface area), followed by areas characterized by very high (20.3%) and moderate (19.3%) vulnerability. Only 16.2% was found to have low vulnerability. A parameter sensitivity analysis showed that distance from shore and depth of GW represent the determining factors for SWI with variation index values of 24.12 and 18.02%, respectively. Inland advancement of seawater is causing GW salinity to rise, as indicated by a strong Pearson correlation coefficient of 0.75 between SWI indices and the electrical conductivity. Suitable areas for artificial recharge were mainly distributed in the alluvial plains, with a total area of 32.85 km2. Inhibiting SWI requires about 11.31 MCM of artificial recharge in the two most suitable recharge zones in the region.
21 February 2015 in Arabian Journal of Geosciences
In Tunisia, most borehole temperatures used to constrain the thermal histories of sedimentary basins were previously corrected using various methods, set to best-fit domains other than the Tunisian basins. This study aimed to propose a new method of borehole temperature correction suitable for the Jeffara Basin, southeastern Tunisia. A total of 92 temperature values including bottomhole temperatures (BHTs) and drill stem test (DST) temperatures were collected from 11 boreholes in the area. The correction method consists of plotting BHT versus DST. The derived equation BHTcorrected=1.036BHTuncorrected+5.9 generates corrected temperatures close to formation temperatures. An error temperature curve following the equation y=2×10−7x2+7.57 was calculated (x = depth in meters and y = temperature error in °C). The error varies from +7.4° to +9.4°C (+45.32° to +48.92°F) at depths below −274 m (−898 ft). A temperature error (ΔT°) is proposed according to depth, and to the time elapsed since mud circulation ceased intervals. To test the method consistency, the Silurian Tannezuft hot shales Formation thermal history is simulated using the BasinMod 1-D™ software program. Two runs were tested based on the new method: (1) noncorrected BHT and (2) corrected BHT. The first run indicates that the Silurian source rock is at an early stage of the oil window. The second run shows that the source rock is mature and even at a late mature stage toward the north. Oil expulsion has occurred even at an oil saturation expulsion threshold of 5%. The results explain gas condensate production in the study area.