Vehicle detection is a key element in traffic management systems. An accurate count will provide the system with proper information so it can make the best decisions. Inductive loops have been used for many years (as physical equipment, or virtual detection in video cameras), and they proved to be a very good choice for road traffic detection. There are also additional solutions, some of them being less accurate, but improved over time, and others being used in specific applications, but can also be considered for vehicle detection in the road network. The latter solution may be represented by the magnetic sensors, typically used in parking systems. In this paper, the authors compared the two solutions, trying to determine if this is a proper alternative for inductive loops in usual traffic conditions.
This paper presents the new radio network technology and applications capability for the “LoRa” systems, which ensure long range data transfer, very high number of local subscribers and low power consume. Although this standard provides low data rates, it is intended to be a solution for sensor networks, that don't need too much information to be transmitted at a specific time. The expectation is that LoRa standard to become, next years, the main data carrier for Smart Cities' infrastructures.
Vehicle to infrastructure communications (V2I) are more and more common in nowadays Intelligent Transport Systems' applications dedicated to increasing safety and reducing driving stress, or to reducing environmental pollution. Telegrams exchanged between moving vehicles and road side units (RSUs) allow the delivery of updated information to traffic participants and gathering important data regarding the number of vehicles passing a certain section of a road, vehicle density on a road section, average speed etc. However, short-range radio communications, automatic handshaking / authentication are challenging features, especially when vehicles move with high velocity. Actual technologies include DSRC and IEEE 802.x standards, but sometimes these become crowded or saturated, preventing effective data exchange. Taking these into account, additional communications technologies such as Bluetooth and ZigBee have been field-tested to evaluate the possibility of supporting extended V2I messaging facilities. Results and recommendations are presented in the paper.
The paper presents a start-up study and tests regarding the possibility of employing ZigBee communications for vehicle-to-infrastructure (V2I) communications. Such communications require less energy consumption, compared to other technologies and are recommended for dense urban areas, where the density of infrastructure equipment reaches higher levels and involves significant power consumption. A prototype for vehicle identification using ZigBee protocol is presented as a solution to test V2I communications in laboratory conditions.
As road traffic conditions worsen due to the constantly increasing number of cars, traffic management systems are struggling to provide a suitable environment, by gathering all the relevant information from the road network. However, in most cases these are obtained via traffic detectors placed near road junctions, thus providing no information on the conditions in between. A large-scale sensor network using detectors on the majority of vehicles would certainly be capable of providing useful data, but has two major impediments: the equipment installed on the vehicles should be cheap enough (assuming the willingness of private car owners to be a part of the network) and be capable of transferring the required amount of data in due time, as the vehicle passes by the road side unit that acts as interface with the traffic management system. These restrictions reduce the number of technologies that can be used. In this article a series of comprehensive tests have been performed to evaluate the Bluetooth and ZigBee protocols for this purpose from many points of view: handshake time, static and dynamic data transfer (in laboratory conditions and in real traffic conditions). An assessment of the environmental conditions (during tests and probable to be encountered in real conditions) was also provided.
As road traffic networks become more congested and information systems are implemented to manage traffic flows, real-time data gathering becomes increasingly important. Classic detectors are placed in one point of the network and are able to provide information only from that area. As useful as this is, it lacks the big picture of the routes the vehicles usually travel. There are applications developed to help individuals make their way into the road network, but these are no solutions that deal with the cause of traffic; rather, they counteract the effects. It becomes obvious that a proper management system, with knowledge of all the relevant aspects will better serve all travelers. The detection solution proposed in this paper is based on Bluetooth detectors. This system is able to match detected devices in the road network, filter the results, and generate a vehicle count that is proved to follow RADAR detection results.