The corrosion behavior of an additively manufactured Mg-1Zn alloy was investigated in both the transverse and longitudinal directions relative to the build direction, in the as-built condition and after annealing at 350 °C for 24 h under high vacuum. Microstructural characterization using XRD and SEM revealed the presence of magnesium oxide (MgO) and the absence of intermetallic second-phase particles. Optical microscopy (OM) images and Electron Backscatter Diffraction (EBSD) maps showed a highly complex grain morphology with anomalous, anisotropic shapes and a heterogeneous grain size distribution. The microstructure includes grains with a pronounced columnar morphology aligned along the build direction and is therefore characterized by a strong crystallographic texture. Electrochemical techniques, including PDP and EIS, along with gravimetric H2 collection, concluded that the transverse plane exhibited greater corrosion resistance compared to the longitudinal plane. Additionally, an increase in cathodic kinetics was observed when comparing as-built with heat-treated samples.
The influence of post-build heat treatments on the microstructure and corrosion behavior of LPBF-processed AZ91 Mg alloy was investigated. Solutionizing and over-aging treatments were applied to modify grain size and the morphology, distribution, and fraction of the β-Mg17Al12 phase. Corrosion behavior was evaluated in 0.1 M NaCl using potentiodynamic polarization, electrochemical impedance spectroscopy, hydrogen evolution measurements, and surface analyses. Over-aging promoted faster anodic kinetics and higher corrosion rates as a consequence of Al depletion from the solid solution and β-phase coarsening. In contrast, solutionizing promoted Al availability in solid solution and the formation of a pseudo-passive surface film, improving global corrosion resistance despite localized pitting.