Li-ion batteries are already being used in several applications, from portable devices to the automotive industry, and they represent a promising option also for other critical uses, such as in the storage of energy from renewable sources. However, two of the main concerns that still hinder their massive introduction in these further areas, are their safety and reliability. Depending on cell characteristics and operating conditions, the heat generated within the cell can exceed that dissipated from its surface, and the cell will fail, possibly with catastrophic consequences. To identify the hazardous working conditions of a cell, a simulation model including the main exothermic reactions was set up to investigate the onset of thermal runaway in several Li-ion cell configurations under various operating conditions. The behavior of four different cathodes under thermal abuse and the influence of external factors such as the environmental temperature and the cooling system efficiency were assessed. It was found that among those investigated, the lithium iron phosphate cathode is characterized by a higher thermal stability and that an efficient superficial heat exchange can prevent thermal runaway in most of the cases.
The aim of this study is to analyze the exergetic, environmental, and economic impact of the electrification of a bio-refinery plant, considering the application of Mechanical Vapor Compression (MVC) to a conventional water–ethanol distillation column in the context of bioethanol production. The process was implemented in AspenPlus® and Aspen Exchange Design and Rating (EDR) simulation environments, where a sensitivity analysis was also carried out, considering four scenarios characterized by different compressions’ operative conditions, and including a Coefficient of Performance (CoP) analysis of the proposed solution with MVC. Exergetic and economic analyses were performed, and the relevant impacts on Operative Expenditure (OpEx) and Capital Expenditure (CapEx) were analyzed. Comparing the base case scenario with the proposed solution, a reduction of operative costs of around 63% was achieved. Finally, an environmental analysis was carried out, showing a remarkable reduction in the carbon footprint of the unit, with a carbon dioxide emission reduction of almost 80% for the MVC solution, in line with RED target requirements.
20 August 2018 in Journal of Thermal Science and Engineering Applications
Temperature control is one of the most significant factors to improve the performance and extend the cycle life of a battery. It is, therefore, important to design and implement an effective battery thermal management system (TMS). Phase change materials (PCMs) can be used as a cooling means for batteries. In the present paper, a preliminary analysis of the thermal behavior of PCMs used to cool down a heated metal surface was carried out. Tests have shown that pure PCMs are able to limit the temperature increase, but only for relatively low-heat fluxes. At higher values of the heat produced, the thermal conductivity of the PCM was increased by using solid foams characterized by higher thermal conductivity; it was, thus, possible to keep the surface temperature within safe limits for longer times. A computational fluid dynamics (CFD) model of the composite material (PCM + solid foam) was also developed, which allowed to predict the temperature trend within the system under different boundary conditions. However, the average thermal conductivity of the composite system that best fitted the experimental results was found to be much lower than that theoretically predicted by using common semiempirical correlations.