Surface plasmon resonance technique in collaboration with optical fiber technology has brought tremendous advancements in sensing of various physical, chemical, and biochemical parameters. In this review article, we present the principle of SPR technique for sensing and various designs of the fiber optic SPR probe reported for the enhancement of the sensitivity of the sensor. In addition, we present few examples of the surface plasmon resonance‐ (SPR‐) based fiber optic sensors. The present review may provide researchers valuable information regarding fiber optic SPR sensors and encourage them to take this area for further research and development.
We have experimentally studied the surface plasmon resonance (SPR)-based fiber-optic refractive index sensor incorporating a high-index dielectric layer using the wavelength interrogation method. Silver and gold have been used as SPR active metals followed by a high-index dielectric layer of silicon. Experimental results predict a redshift in the resonance wavelength with the increase in the refractive index of the sensing layer for a given thickness of the silicon layer. Further, as the thickness of the silicon layer increases, the sensitivity of the sensor increases. The upper limit of the silicon film thickness for the enhancement of the sensitivity has been found to be around . The experimental results obtained on sensitivity match qualitatively with the theoretical results obtained using the N-layer model and the ray approach. The increase in sensitivity is due to the increase in the electric field intensity at the silicon-sensing-region interface. In addition to an increase in sensitivity, the silicon layer can be used to tune the resonance wavelength and can protect the metal layer from oxidation and hence can improve the durability of the probe.
We report an experimental study on a surface plasmon resonance (SPR)-based fiber optic hydrogen sulphide gas sensor with a thin metal oxide (zinc oxide (ZnO)) layer as the additional layer. This zinc oxide layer is grown over the copper layer to support surface plasmons at the metal–dielectric interface at room temperature. The wavelength interrogation mode of operation has been used to characterize the sensor. The thin film of zinc oxide over the copper film was deposited on the unclad portion of the fiber by the thermal evaporation technique. Experiments were performed for the detection of concentrations of hydrogen sulphide gas varying from 0 to 100 ppm around the probe. The unpolarized light from a polychromatic source is launched from one end of the fiber and the corresponding SPR spectrum is recorded at the other end. The recorded SPR spectrum shows a shift in the resonance wavelength on a change in the hydrogen sulphide gas concentration, which is considered as a detectable signal for the characterization of the sensor. Further, the optimization of the performance of the sensor was achieved by varying the thickness of the zinc oxide film. The sensor possesses a very fast response time and high sensitivity. Since the sensor utilizes optical fibers it has additional advantages of remote sensing, online monitoring, light weight and low cost.