After a brief introduction to the field of light-responsive materials, this paper provides a general theory for modeling the photomechanical response of a material, applies it to the two best-known mechanisms of photothermal heating and photoisomerization, and then describes an experimental procedure for quantitative measurements of the stress response. Several different materials are characterized to illustrate how the experiments and theory can be used to isolate the contributing mechanisms through both photomechanical measurements and auxiliary measurements of laser heating and thermal expansion. The efficiency and figure of merit of the photomechanical response are defined on several scales from the molecule to the bulk, and the photomorphon—the basic material element that determines the bulk response—is introduced. The photomorphon provides a conceptual model that can be expressed in terms of viscoelastic elements, such as springs in series and parallel with the photoactive molecule. The photomechanical response, figure of merit, and the deduced microscopic photomechanical properties are tabulated and proposals for new materials classes are made.
The paper demonstrates a dual-cell smart window based on dichroic-dyed-doped liquid crystal that is switchable among transparent, dark and scattering states. The dual-cell forms the crossed-polariser structure so very low transmittance is achieved. To characterise the concentration of ions in cells, voltage holding ratios with and without doping the dyes are measured. Polarisation optical microscopy (POM) of single cell that shows the transition from Freedericksz regime to turbulent state is also shown. In addition, the polarised and non-polarised voltage-transmittance and haze characteristics of the cells are measured. The increase in transmittance of dual cell after Freedericksz regime is explained and verified by simulations. By identifying the voltage when transmittance first increases as the threshold voltage of triggering electrohydrodynamic instabilities (EHDIs), its dependence on temperature, waveform, amplitude and frequency of driving voltage is investigated. Graphical abstract
This work is a comprehensive experimental and theoretical study aimed at understanding the photothermal and molecular shape-change contributions to the photomechanical effect of polymers doped with azo dyes. Our prototypical system is the azobenzene dye Disperse Red 1 (DR1) doped into poly (methyl methacrylate) (PMMA) polymer formed into optical fibers. We start by determining the thermo-mechanical properties of the materials with a temperature-dependent stress measurement. The material parameters, so determined, are used in a photothermal heating model—with no adjustable parameters—to predict its contribution. The photothermal heating model predicts the observations, ruling out mechanisms originating in light-induced shape changes of the dopant molecules. The photomechanical tensor response along the two principle axes in the uniaxial approximation is measured and compared with another independent theory of photothermal heating and angular hole burning/reorientation. Again, the results are consistent only with a purely thermal response, showing that effects due to light-induced shape changes of the azo dyes are negligible. The measurements are repeated as a function of polymer chain length and the photomechanical efficiencies determined. We find the results to be mostly chain-length independent.
This work studies the effect of azobenzene dye Disperse Red 1 (DR1) doping and annealing on the thermomechanical and photomechanical properties of poly(methyl methacrylate) (PMMA) fibers. The mechanical properties are measured as a function of temperature, pump light intensity, and polarization. We find that doping with DR1 increases the stiffness and the glass transition temperature () of the PMMA fibers. Moreover, annealing below decreases Young’s modulus and increases . Finally, the photothermal heating contribution to the photomechanical response and the length change during laser exposure are determined in both unannealed and annealed plain PMMA and DR1-doped PMMA fibers. We find that photothermal heating is the dominant mechanism and the effect of photoisomerization is negligible. The temperature-dependent photomechanical efficiencies are also determined.