Iso-Octane (2,2,4-trimethlypentane) is an important gasoline primary reference fuel (PRF) surrogate. Auto ignition of iso-octane was examined using a rapid compression machine (RCM) with iso-octane, air and carbon dioxide (CO2) mixtures. Experiments were conducted over a temperature range of 650K-900K at 20bar and 10 bar compressed conditions for equivalence ratios (Φ =) 0.6, 0.8, 1.0 and 1.3. CO2 dilution by mass was introduced at 0%, 15% and 30% levels with the O2:N2 mole ratio fixed at 1:3.76 emulating the exhaust gas recirculation (EGR) substitution in spark ignition (SI) engines. In this study the direct test chamber (DTC) approach is used for introducing iso-octane directly into the RCM test chamber via a direct injector. The results using this approach are compared with other RCM data available in the literature at undiluted Φ = 1.0 and 20 bar compressed pressure and show good agreement. For a given equivalence ratio, the negative temperature coefficient (NTC) region was fixed irrespective of the dilution levels confirming the fact that CO2 does not participate in the chemistry of the base fuel but rather reduces the reactivity leading to increased ignition delay times. At 30% dilution levels the increase in ignition delay times is more than twice that of the 15% dilution levels for the same compressed conditions and stoichiometry.
Ignition delay, using a rapid compression machine (RCM), is defined as the time period between the end of compression and the maximum rate of pressure rise due to combustion, at a given compressed condition of temperature and pressure. The same compressed conditions can be reached by a variety of combinations of compression ratio, initial temperature, initial pressure, diluent gas composition, etc. It has been assumed that the value of ignition delay, for a given fuel and at a given set of compressed conditions, would be the same, irrespective of the variety of the above-mentioned combinations that were used to achieve the compressed conditions. In this study, a range of initial conditions and compression ratios are studied to determine their effect on ignition delay time and to show how ignition delay time can differ even at the same compressed conditions. Experiments were carried out at two compression ratio conditions (11.7 and 17.1) for stoichiometric ethanol-air mixtures over a temperature range of 800 K - 875 K at 20 bar pressure. With the help of optical images, in addition to the pressure traces, the combustion characteristics for the abovementioned conditions were analyzed and compared. Another factor that was determined to be important in consistent ignition delay measurements was the cleanliness of the combustion chamber and some discussion on the suggested protocol is included.
14 April 2020 in SAE International Journal of Advances and Current Practices in Mobility
Previous studies have shown that several facility dependent factors can influence ignition delay times measured in a rapid compression machine. Compression ratio variation represents one such aspect of many facility-to facility differences in RCMs, and can have a major impact on measured ignition delay times due to changes in surface-area-to-volume ratio, initial conditions and compression duration even when the same compressed conditions are maintained. In this study, iso-octane, which exhibits two stage ignition delay and has a pronounced negative temperature coefficient (NTC) region, is used to investigate the effects of changing compression ratio on ignition delay. Resulting trends are also compared to previous results obtained with ethanol, which has very different combustion properties. Experiments were carried out for rich mixtures (ϕ = 1.3) of iso-octane and air over a compressed temperature range of 675-900 K at 20 bar compressed pressure. Two compression ratios are considered for each case with initial temperature and pressure adjusted in conjunction to achieve the identical compressed condition. The compression ratio was varied from 6.8 to 17.1 which also led to changes in initial conditions, compression time and surface area-to-volume ratio, all of which together affected the ignition delay time at a given compressed condition.